Hi Sakari, On Fri, Aug 11, 2023 at 09:11:39AM +0000, Sakari Ailus wrote: > On Fri, Aug 11, 2023 at 08:31:16AM +0200, Jacopo Mondi wrote: > > > > +V4L2_META_FMT_GENERIC_CSI2_10 > > > > +----------------------------- > > > > + > > > > +V4L2_META_FMT_GENERIC_CSI2_10 contains packed 8-bit generic metadata, 10 bits > > > > +for each 8 bits of data. Every four bytes of metadata is followed by a single > > > > +byte of padding. The way the data is stored follows the CSI-2 specification. > > > > + > > > > +This format is also used on CSI-2 on 20 bits per sample format that packs two > > > > +bytes of metadata into one sample. > > > > + > > > > +This format is little endian. > > > > + > > > > +**Byte Order Of V4L2_META_FMT_GENERIC_CSI2_10.** > > > > +Each cell is one byte. "M" denotes a byte of metadata and "p" a byte of padding. > > > > > > I think you should document whether the padding is always 0 or can be any value. > > > Perhaps 'X' is a better 'name' for the padding byte in the latter case. > > > > Did I get this right that this format is supposed to work as the RAW10 > > CSI-2 packed image format, where 4 bytes contain the higher 8 bits of > > the 10 bits sample and the 5th byte every 4 contains the lower 2 bits of > > the previous 4 sample ? > > > > If that's the case, is 'padding' the correct term here ? > > What else would you call it? It'll be zeros that exist just due to the bit > depth used and as such not interesting at all. It's actually not 0, CCS requires the padding bytes to be 0x55. I wonder if the conformance test suite tests the contents of the padding bytes. -- Regards, Laurent Pinchart
