Hi Hermann,
I finally found the time to wire analog antena and I checked it with
my TV if it is working correctly.
Since I am using local cable provider which didn't upgrade their
system in 10 years and they are still broadcast in analog, I had a
problem off finding channel list, so in the end I tried tvtime-scanner
and it found about 58 channels. But, out of this 58 most of them were
not good (no signal). I was able to finetune few programs. My main
programs (local Croatian TV stations) were not found. Maybe I need to
finetune every found station.
I also tried zapping which crashed my X.
I am also lost in setting mythtv. I set analog tunner on /dev/video0.
But I think I have a problem of setting the channel list for my local
cable provider. Is it possible to scan whole list or something. If you
have any reading recommendation to set this, I would be helpfull
Thanks
--
Dejan Rodiger
S: callto://drodiger
On Thu, Sep 23, 2010 at 00:46, <hermann-pitton@xxxxxxxx> wrote:
>
>
> Hi Dejan,
>
> ----- Original Nachricht ----
> Von: Â Â Dejan Rodiger <dejan.rodiger@xxxxxxxxx>
> An: Â Â Âhermann pitton <hermann-pitton@xxxxxxxx>
> Datum: Â 22.09.2010 13:20
> Betreff: Re: [linux-dvb] Asus MyCinema P7131 Dual support
>
>> Hi Herman,
>>
>> here is dmesg output without forcing card=78.
>> As I see it uses card=112, autodetected
>>
>> [ Â 16.043345] IR RC6 protocol handler initialized
>> [ Â 16.173473] IR JVC protocol handler initialized
>> [ Â 16.236641] IR Sony protocol handler initialized
>> [ Â 16.433187] lirc_dev: IR Remote Control driver registered, major 250
>> [ Â 16.572705] IR LIRC bridge handler initialized
>> [ Â 16.894983] Linux video capture interface: v2.00
>> [ Â 16.957585] saa7130/34: v4l2 driver version 0.2.16 loaded
>> [ Â 16.958300] ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
>> [ Â 16.958306] Â alloc irq_desc for 18 on node 0
>> [ Â 16.958309] Â alloc kstat_irqs on node 0
>> [ Â 16.958320] saa7134 0000:01:06.0: PCI INT A -> Link[APC3] -> GSI 18
>> (level, low) -> IRQ 18
>> [ Â 16.958327] saa7133[0]: found at 0000:01:06.0, rev: 209, irq: 18,
>> latency: 32, mmio: 0xfdeff000
>> [ Â 16.958334] saa7133[0]: subsystem: 1043:4876, board: ASUSTeK P7131
>> Hybrid [card=112,autodetected]
>> [ Â 16.958378] saa7133[0]: board init: gpio is 0
>> [ Â 17.010075] Registered IR keymap rc-asus-pc39
>> [ Â 17.010197] input: saa7134 IR (ASUSTeK P7131 Hybri as
>> /devices/pci0000:00/0000:00:09.0/0000:01:06.0/rc/rc0/input4
>> [ Â 17.010268] rc0: saa7134 IR (ASUSTeK P7131 Hybri as
>> /devices/pci0000:00/0000:00:09.0/0000:01:06.0/rc/rc0
>> [ Â 17.190477] saa7133[0]: i2c eeprom 00: 43 10 76 48 54 20 1c 00 43
>> 43 a9 1c 55 d2 b2 92
>> [ Â 17.190490] saa7133[0]: i2c eeprom 10: ff ff ff 0f ff 20 ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190502] saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08
>> ff 00 d5 ff ff ff ff
>> [ Â 17.190513] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190524] saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 55
>> 50 ff ff ff ff ff ff
>> [ Â 17.190534] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190545] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190556] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190566] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190577] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190587] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190598] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190609] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190620] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190630] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>> [ Â 17.190641] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff
>> ff ff ff ff ff ff ff
>>
>> [ Â 17.610120] tuner 2-004b: chip found @ 0x96 (saa7133[0])
>>
>> [ Â 17.780037] tda829x 2-004b: setting tuner address to 61
>> [ Â 17.940020] tda829x 2-004b: type set to tda8290+75a
>>
>> [ Â 24.000114] saa7133[0]: registered device video0 [v4l2]
>> [ Â 24.000150] saa7133[0]: registered device vbi0
>> [ Â 24.000182] saa7133[0]: registered device radio0
>> [ Â 24.027730] saa7134 ALSA driver for DMA sound loaded
>> [ Â 24.027770] saa7133[0]/alsa: saa7133[0] at 0xfdeff000 irq 18
>> registered as card -2
>>
>> [ Â 25.900159] DVB: registering new adapter (saa7133[0])
>> [ Â 25.900165] DVB: registering adapter 0 frontend 0 (Philips
>> TDA10046H DVB-T)...
>>
>> [ Â 26.710050] tda1004x: setting up plls for 48MHz sampling clock
>> [ Â 27.710043] tda1004x: found firmware revision 29 -- ok
>>
>>
>> --
>> Dejan Rodiger
>> M: +385917829076
>> S: callto://drodiger
>>
>
> all looks fine now.
>
> With auto detection you should have correct LNA support for analog tuning and DVB-T.
>
> You need to connect the DVB-T signal to the FM/RF antenna input and the analog TV signal
> to the cable RF input..
>
> If you plug in the remote receiver, gpio 0x040000 will switch to high.
>
> Does this help any further?
>
> What went wrong previously, making you think you might have to force for example card = 78 ?
>
> I can revive almost all of the Asus cards on the saa713x driver if needed.
>
> Have fun, hopefully.
>
> Cheers,
> Hermann
>
>
>>
>> On Wed, Sep 22, 2010 at 01:13, hermann pitton <hermann-pitton@xxxxxxxx>
>> wrote:
>> > Hi Dejan,
>> >
>> > Am Dienstag, den 21.09.2010, 10:07 +0200 schrieb Dejan Rodiger:
>> >> Hi,
>> >>
>> >> I am using Ubuntu linux 10.10 with the latest kernel 2.6.35-22-generic
>> >> on x86_64. I have installed nonfree firmware which should support this
>> >> card, but to be sure, can somebody confirm that my TV card is
>> >> supported in Analog or DVB mode?
>> >>
>> >> sudo lspci -vnn
>> >> 01:06.0 Multimedia controller [0480]: Philips Semiconductors
>> >> SAA7131/SAA7133/SAA7135 Video Broadcast Decoder [1131:7133] (rev d1)
>> >> Â Â Â Â Subsystem: ASUSTeK Computer Inc. My Cinema-P7131 Hybrid
>> >> [1043:4876]
>> >> Â Â Â Â Flags: bus master, medium devsel, latency 32, IRQ 18
>> >> Â Â Â Â Memory at fdeff000 (32-bit, non-prefetchable) [size=2K]
>> >> Â Â Â Â Capabilities: [40] Power Management version 2
>> >> Â Â Â Â Kernel driver in use: saa7134
>> >> Â Â Â Â Kernel modules: saa7134
>> >>
>> >> It says Hybrid, but I put the following in
>> >> the /etc/modprobe.d/saa7134.conf
>> >> options saa7134 card=78 tuner=54
>> >>
>> >>
>> >> Thanks
>> >> --
>> >> Dejan Rodiger
>> >> S: callto://drodiger
>> >
>> > don't have time to follow this closely anymore.
>> >
>> > But forcing it to card=78 is plain wrong. It has an early additional LNA
>> > in confirmed config = 2 status.
>> >
>> > Your card should be auto detected and previously always was, based on
>> > what we have in saa7134-cards.c and further for it. (saa7134-dvb and
>> > related tuner/demod stuff)
>> >
>> > Â Â Â Â}, {
>> >        Â.vendor    = PCI_VENDOR_ID_PHILIPS,
>> >        Â.device    = PCI_DEVICE_ID_PHILIPS_SAA7133,
>> >        Â.subvendor  Â= 0x1043,
>> >        Â.subdevice  Â= 0x4876,
>> > Â Â Â Â Â Â Â Â.driver_data Â= SAA7134_BOARD_ASUSTeK_P7131_HYBRID_LNA,
>> > Â Â Â Â},{
>> >
>> > I remember for sure, that this card was fully functional for all use
>> > cases and it was not easy to get it there. I don't have it.
>> >
>> > Please provide the "dmesg" for failing auto detection without forcing
>> > some card = number as a starting point.
>> >
>> > I for sure want to see this board fully functional again.
>> >
>> > Cheers,
>> > Hermann
>> >
>
>
> Heute erleben, was morgen Trend wird - das kann man auf der IFA in Berlin. Oder auf arcor.de: Wir stellen Ihnen die wichtigsten News, Trends und Gadgets der IFA vor. NatÃrlich mit dabei: das brandneue IPTV-Angebot von Vodafone! Alles rund um die Internationale Funkausstellung in Berlin finden Sie hier: http://www.arcor.de/rd/footer.ifa2010
>
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
