Commit "97589ad61c73 media: i2c: imx290: Add support for 2 data lanes"
added support for running in two lane mode (instead of 4), but
without changing the link frequency that resulted in a max of 30fps.
Commit "98e0500eadb7 media: i2c: imx290: Add configurable link frequency
and pixel rate" then doubled the link frequency when in 2 lane mode,
but didn't undo the correction for running at only 30fps, just extending
horizontal blanking instead.
Remove the 30fps limit on 2 lane by correcting the register config
in accordance with the datasheet for 60fps operation over 2 lanes.
Signed-off-by: Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx>
---
drivers/media/i2c/imx290.c | 17 +++--------------
1 file changed, 3 insertions(+), 14 deletions(-)
diff --git a/drivers/media/i2c/imx290.c b/drivers/media/i2c/imx290.c
index bd8729aed43c..6bcfa535872f 100644
--- a/drivers/media/i2c/imx290.c
+++ b/drivers/media/i2c/imx290.c
@@ -366,7 +366,7 @@ static const struct imx290_mode imx290_modes_2lanes[] = {
{
.width = 1920,
.height = 1080,
- .hmax = 4400,
+ .hmax = 2200,
.link_freq_index = FREQ_INDEX_1080P,
.data = imx290_1080p_settings,
.data_size = ARRAY_SIZE(imx290_1080p_settings),
@@ -374,7 +374,7 @@ static const struct imx290_mode imx290_modes_2lanes[] = {
{
.width = 1280,
.height = 720,
- .hmax = 6600,
+ .hmax = 3300,
.link_freq_index = FREQ_INDEX_720P,
.data = imx290_720p_settings,
.data_size = ARRAY_SIZE(imx290_720p_settings),
@@ -518,21 +518,10 @@ static int imx290_set_register_array(struct imx290 *imx290,
static int imx290_set_data_lanes(struct imx290 *imx290)
{
int ret = 0;
- u32 frsel;
-
- switch (imx290->nlanes) {
- case 2:
- default:
- frsel = 0x02;
- break;
- case 4:
- frsel = 0x01;
- break;
- }
imx290_write(imx290, IMX290_PHY_LANE_NUM, imx290->nlanes - 1, &ret);
imx290_write(imx290, IMX290_CSI_LANE_MODE, imx290->nlanes - 1, &ret);
- imx290_write(imx290, IMX290_FR_FDG_SEL, frsel, &ret);
+ imx290_write(imx290, IMX290_FR_FDG_SEL, 0x01, &ret);
return ret;
}
--
2.34.1
