There's no need to check for an incorrect number of data lanes in
imx290_set_data_lanes() as the value is validated at probe() time. Drop
the check.
The PHY_LANE_NUM and CSI_LANE_MODE registers are programmed with a value
equal to the number of lanes minus one. Compute it instead of handling
it in the switch/case.
Signed-off-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
Reviewed-by: Alexander Stein <alexander.stein@xxxxxxxxxxxxxxx>
---
drivers/media/i2c/imx290.c | 17 +++++------------
1 file changed, 5 insertions(+), 12 deletions(-)
diff --git a/drivers/media/i2c/imx290.c b/drivers/media/i2c/imx290.c
index 34278d098218..bb8713813e29 100644
--- a/drivers/media/i2c/imx290.c
+++ b/drivers/media/i2c/imx290.c
@@ -512,28 +512,21 @@ static int imx290_set_register_array(struct imx290 *imx290,
static int imx290_set_data_lanes(struct imx290 *imx290)
{
- int ret = 0, laneval, frsel;
+ int ret = 0;
+ u32 frsel;
switch (imx290->nlanes) {
case 2:
- laneval = 0x01;
+ default:
frsel = 0x02;
break;
case 4:
- laneval = 0x03;
frsel = 0x01;
break;
- default:
- /*
- * We should never hit this since the data lane count is
- * validated in probe itself
- */
- dev_err(imx290->dev, "Lane configuration not supported\n");
- return -EINVAL;
}
- imx290_write(imx290, IMX290_PHY_LANE_NUM, laneval, &ret);
- imx290_write(imx290, IMX290_CSI_LANE_MODE, laneval, &ret);
+ imx290_write(imx290, IMX290_PHY_LANE_NUM, imx290->nlanes - 1, &ret);
+ imx290_write(imx290, IMX290_CSI_LANE_MODE, imx290->nlanes - 1, &ret);
imx290_write(imx290, IMX290_FR_FDG_SEL, frsel, &ret);
return ret;
--
Regards,
Laurent Pinchart
