From: Luis Oliveira <Luis.Oliveira@xxxxxxxxxxxx>
Add device-tree bindings documentation for SNPS DesignWare MIPI D-PHY in
RX mode.
Signed-off-by: Luis Oliveira <luis.oliveira@xxxxxxxxxxxx>
---
.../bindings/phy/snps,dw-dphy-rx.txt | 29 +++++++++++++++++++
1 file changed, 29 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/snps,dw-dphy-rx.txt
diff --git a/Documentation/devicetree/bindings/phy/snps,dw-dphy-rx.txt b/Documentation/devicetree/bindings/phy/snps,dw-dphy-rx.txt
new file mode 100644
index 000000000000..ffb64fe5cbd1
--- /dev/null
+++ b/Documentation/devicetree/bindings/phy/snps,dw-dphy-rx.txt
@@ -0,0 +1,29 @@
+Synopsys DesignWare MIPI Rx D-PHY block details
+
+Description
+-----------
+
+The Synopsys MIPI D-PHY controller supports MIPI-DPHY in receiver mode.
+Please refer to phy-bindings.txt for more information.
+
+Required properties:
+- compatible : Shall be "snps,dw-dphy-rx".
+- #phy-cells : Must be 1.
+- bus-width : Size of the test interface data bus (8 bits->8 or
+ 12bits->12).
+- snps,dphy-frequency : Frequency at which D-PHY should start, configurable.
+ Check Synopsys databook. (-kHz)
+- reg : Test interface register. This correspondes to the
+ physical base address of the controller and size of
+ the device memory mapped registers; Check Synopsys
+ databook.
+
+Example:
+
+ mipi_dphy_rx1: dphy@d00003040 {
+ compatible = "snps,dw-dphy-rx";
+ #phy-cells = <1>;
+ bus-width = <12>;
+ snps,dphy-frequency = <300000>;
+ reg = <0xd0003040 0x20>;
+ };
--
2.25.1
