On 05/12/2022 03:38, lee.jackson wrote: > Add YAML device tree binding for IMX519 CMOS image sensor, and > the relevant MAINTAINERS entries. > > Signed-off-by: lee.jackson <lee.jackson@xxxxxxxxxxx > That's still not correct entry. Except trailing space, are you sure that in your documents (national ID, passport) the Latin transliteration of your name is with a dot between names? Since it is a third try, it's getting more and more confusing. > --- > .../bindings/media/i2c/sony,imx519.yaml | 107 ++++++++++++++++++ > MAINTAINERS | 8 ++ > 2 files changed, 115 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/i2c/sony,imx519.yaml > > diff --git a/Documentation/devicetree/bindings/media/i2c/sony,imx519.yaml b/Documentation/devicetree/bindings/media/i2c/sony,imx519.yaml > new file mode 100644 > index 000000000000..d7ca16cfbacc > --- /dev/null > +++ b/Documentation/devicetree/bindings/media/i2c/sony,imx519.yaml > @@ -0,0 +1,107 @@ > +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/media/i2c/sony,imx519.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Sony 1/2.5-Inch 16Mpixel CMOS Digital Image Sensor > + > +maintainers: > + - lee.jackson <lee.jackson@xxxxxxxxxxx> Same question. > + > +description: |- > + The Sony IMX519 is a 1/2.5-inch CMOS active pixel digital image sensor > + with an active array size of 4656H x 3496V. It is programmable through > + I2C interface. The I2C address is fixed to 0x1A as per sensor data sheet. > + Image data is sent through MIPI CSI-2, which is configured as either 2 or > + 4 data lanes. > + > +properties: > + compatible: > + const: sony,imx519 > + > + reg: > + maxItems: 1 > + > + clocks: > + maxItems: 1 > + > + vdig-supply: > + description: > + Digital I/O voltage supply, 1.05 volts > + > + vana-supply: > + description: > + Analog voltage supply, 2.8 volts > + > + vddl-supply: > + description: > + Digital core voltage supply, 1.8 volts > + > + reset-gpios: maxItems: 1 > + description: |- No need for |- > + Reference to the GPIO connected to the xclr pin, if any. > + Must be released (set high) after all supplies and INCK are applied. > + > + port: > + $ref: /schemas/graph.yaml#/$defs/port-base > + additionalProperties: false > + Best regards, Krzysztof
