Hi Marek, Thank you for the patch. On Wed, Aug 24, 2022 at 12:22:16AM +0200, Marek Vasut wrote: > The MT9P006 sensor driver sporadically fails to probe because the sensor > responds with a NACK condition to I2C address on the bus during an attempt > to read the sensor MT9P031_CHIP_VERSION register in mt9p031_registered(). > > Neither the MT9P006 nor MT9P031 datasheets are clear on reset signal timing. > Older MT9M034 [1] datasheet provides those timing figures in Appendix-A and > indicates it is necessary to wait 850000 EXTCLK cycles before starting any > I2C communication. > > Add such a delay, which does make the sporadic I2C NACK go away, so it is > likely similar constraint applies to this sensor. > > [1] https://www.onsemi.com/pdf/datasheet/mt9m034-d.pdf > > Signed-off-by: Marek Vasut <marex@xxxxxxx> Given the lack of information regarding the MT9P006 reset timings, this seems to be the best we can do. Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > --- > Cc: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > Cc: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx> > Cc: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> > Cc: Stefan Riedmueller <s.riedmueller@xxxxxxxxx> > --- > V2: - In case clk_get_rate() returns 0, use slowest supported clock > to avoid division by zero > --- > drivers/media/i2c/mt9p031.c | 8 +++++++- > 1 file changed, 7 insertions(+), 1 deletion(-) > > diff --git a/drivers/media/i2c/mt9p031.c b/drivers/media/i2c/mt9p031.c > index 45f7b5e52bc39..5f5caafe56887 100644 > --- a/drivers/media/i2c/mt9p031.c > +++ b/drivers/media/i2c/mt9p031.c > @@ -307,6 +307,7 @@ static inline int mt9p031_pll_disable(struct mt9p031 *mt9p031) > > static int mt9p031_power_on(struct mt9p031 *mt9p031) > { > + unsigned long rate, delay; > int ret; > > /* Ensure RESET_BAR is active */ > @@ -334,7 +335,12 @@ static int mt9p031_power_on(struct mt9p031 *mt9p031) > /* Now RESET_BAR must be high */ > if (mt9p031->reset) { > gpiod_set_value(mt9p031->reset, 0); > - usleep_range(1000, 2000); > + /* Wait 850000 EXTCLK cycles before de-asserting reset. */ > + rate = clk_get_rate(mt9p031->clk); > + if (!rate) > + rate = 6000000; /* Slowest supported clock, 6 MHz */ > + delay = DIV_ROUND_UP(850000 * 1000, rate); > + msleep(delay); > } > > return 0; -- Regards, Laurent Pinchart
