Re: [PATCH v4 4/4] media: platform: Add Renesas RZ/G2L CRU driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Prabhakar,

On Thu, Oct 27, 2022 at 08:04:40PM +0100, Lad, Prabhakar wrote:
...
> > > +static int rzg2l_cru_ip_s_stream(struct v4l2_subdev *sd, int enable)
> > > +{
> > > +     struct rzg2l_cru_dev *cru;
> > > +     int ret;
> > > +
> > > +     cru = v4l2_get_subdevdata(sd);
> > > +
> > > +     if (!cru->is_csi)
> > > +             return -EINVAL;
> > > +
> > > +     ret = v4l2_subdev_call(cru->ip.remote, video, s_stream, enable);
> >
> > It's up to the driver how call pre_streamon() and post_streamoff(), as long
> > as it takes place on both sides of s_stream().
> >
> > In other words, as it seems your device doesn't need anything special, you
> > could waive implemeting the callbacks yourself and call pre_streamon() and
> > post_streamoff() here.
> >
> Here the cru->ip.remote = CSI, in the rzg2l_cru_set_stream(1) where we
> are calling pre_streamon()/post_streamoff() callbacks the subdev is
> CRU-IP. So the calls from rzg2l_cru_set_stream() land into
> rzg2l_cru_ip_pre_streamon() and rzg2l_cru_ip_post_streamoff() which
> are calling pre_streamon/post_streamoff for the CSI subdev.

Again, you should call the source sub-device's pre_streamon and
post_streamoff from the s_stream handler (not from
rzg2l_cru_ip_pre_streamon or rzg2l_cru_ip_post_streamoff).

Starting streaming takes place link by link. This allows a driver to omit
implementing pre_streamon and post_streamon callbacks if it doesn't need
them.

-- 
Kind regards,

Sakari Ailus



[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux