Hi, With a lot of help from Marko Ristola I finally made my tv-card register correctly. I'm using the followin tree: http://jusst.de/hg/mantis-v4l-dvb/ (14421:0e6ee2a233f0). With the changes, that i have appended below, the frontend (zl10353) is registered. However I don't see any channels when I scan with kaffeine. I also tried the "scan"-utility from dvb-apps. What can I do now? niklas@niklas-desktop:~$ scan dvbtmp scanning dvbtmp using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' ERROR: initial tuning failed dumping lists (0 services) Done. At the same time the following occurs in syslog: mantis_i2c_xfer (0): Messages:2 Byte MODE: Byte <0> RXD=0x1f500c80 [0c] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 50 03 ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 51 64 ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 52 46 ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 53 15 ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 54 0f ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 50 0c ] mantis_i2c_xfer (0): Messages:1 mantis_i2c_write: Address=[0x0f] <W>[ 51 44 ] Successful probing in syslog: Mantis 0000:05:02.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 DVB: registering new adapter (Mantis DVB adapter) My demodulator id is 14 tda665x_attach: Attaching TDA665x (ENV57H12D5 (ET-50DT)) tuner DVB: registering adapter 0 frontend 0 (Zarlink ZL10353 DVB-T)... Mantis 0000:05:02.0: PCI INT A disabled found a VP-3030 PCI DVB-T device on (05:02.0), Mantis 0000:05:02.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 Mantis Rev 1 [1822:0024], irq: 23, latency: 64 memory: 0x0, mmio: 0xfb904000 mantis_stream_control (0): Set stream to HIF mantis_i2c_init (0): Initializing I2C .. mantis_i2c_init (0): Disabling I2C interrupt mantis_i2c_xfer (0): Messages:2 mantis_i2c_write: Address=[0x50] <W>[ 08 ] mantis_i2c_read: Address=[0x50] <R>[ 00 08 ca 1a 4d f6 ] MAC Address=[00:08:ca:1a:4d:f6] mantis_dma_init (0): Mantis DMA init mantis_alloc_buffers (0): DMA=0x33b00000 cpu=0xf3b00000 size=65536 mantis_alloc_buffers (0): RISC=0x33928000 cpu=0xf3928000 size=1000 mantis_calc_lines (0): Mantis RISC block bytes=[4096], line bytes=[2048], line count=[32] mantis_dvb_init (0): dvb_register_adapter DVB: registering new adapter (Mantis DVB adapter) mantis_dvb_init (0): dvb_dmx_init mantis_dvb_init (0): dvb_dmxdev_init mantis_frontend_power (0): Power ON gpio_set_bits (0): Set Bit <12> to <1> gpio_set_bits (0): GPIO Value <3000> gpio_set_bits (0): Set Bit <12> to <1> gpio_set_bits (0): GPIO Value <3000> mantis_frontend_soft_reset (0): Frontend RESET gpio_set_bits (0): Set Bit <13> to <0> gpio_set_bits (0): GPIO Value <1000> gpio_set_bits (0): Set Bit <13> to <0> gpio_set_bits (0): GPIO Value <1000> gpio_set_bits (0): Set Bit <13> to <1> gpio_set_bits (0): GPIO Value <3000> gpio_set_bits (0): Set Bit <13> to <1> gpio_set_bits (0): GPIO Value <3000> vp3030_frontend_init (0): Probing for 10353 (DVB-T) mantis_i2c_xfer (0): Messages:2 Byte MODE: Byte <0> RXD=0x1f7f1480 [14] tda665x_attach: Attaching TDA665x (ENV57H12D5 (ET-50DT)) tuner vp3030_frontend_init (0): Done! DVB: registering adapter 0 frontend 0 (Zarlink ZL10353 DVB-T)... mantis_input_init (0): No RC codes available mantis_uart_init (0): Initializing UART @ 9600bps parity:NONE mantis_uart_init (0): UART succesfully initialized mantis_uart_read (0): Reading ... <3f> mantis_uart_work (0): UART BUF:0 <3f> Changes to make it probe correctly: diff -r 0e6ee2a233f0 linux/drivers/media/dvb/mantis/mantis_i2c.c --- a/linux/drivers/media/dvb/mantis/mantis_i2c.c Thu Feb 11 18:30:37 2010 +0400 +++ b/linux/drivers/media/dvb/mantis/mantis_i2c.c Mon Jul 19 17:37:56 2010 +0200 @@ -158,6 +158,7 @@ mmwrite(txd, MANTIS_I2CDATA_CTL); /* wait for xfer completion */ for (trials = 0; trials < TRIALS; trials++) { + udelay(500); stat = mmread(MANTIS_INT_STAT); if (stat & MANTIS_INT_I2CDONE) break; diff -r 0e6ee2a233f0 linux/drivers/media/dvb/mantis/mantis_vp3030.c --- a/linux/drivers/media/dvb/mantis/mantis_vp3030.c Thu Feb 11 18:30:37 2010 +0400 +++ b/linux/drivers/media/dvb/mantis/mantis_vp3030.c Mon Jul 19 17:37:56 2010 +0200 @@ -77,17 +77,12 @@ static int vp3030_frontend_init(struct mantis_pci *mantis, struct dvb_frontend *fe) { struct i2c_adapter *adapter = &mantis->adapter; - struct mantis_hwconfig *config = mantis->hwconfig; + int err = 0; - gpio_set_bits(mantis, config->reset, 0); - msleep(100); err = mantis_frontend_power(mantis, POWER_ON); - msleep(100); - gpio_set_bits(mantis, config->reset, 1); - if (err == 0) { - msleep(250); + mantis_frontend_soft_reset(mantis); dprintk(MANTIS_ERROR, 1, "Probing for 10353 (DVB-T)"); fe = zl10353_attach(&mantis_vp3030_config, adapter); Regards, Niklas Claesson -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
