Il 12/11/21 11:54, Yong Wu ha scritto:
MediaTek IOMMU-SMI diagram is like below. all the consumer connect with
smi-larb, then connect with smi-common.
M4U
|
smi-common
|
-------------
| | ...
| |
larb1 larb2
| |
vdec venc
When the consumer works, it should enable the smi-larb's power which
also need enable the smi-common's power firstly.
Thus, First of all, use the device link connect the consumer and the
smi-larbs. then add device link between the smi-larb and smi-common.
This patch adds device_link between the consumer and the larbs.
When device_link_add, I add the flag DL_FLAG_STATELESS to avoid calling
pm_runtime_xx to keep the original status of clocks. It can avoid two
issues:
1) Display HW show fastlogo abnormally reported in [1]. At the beggining,
all the clocks are enabled before entering kernel, but the clocks for
display HW(always in larb0) will be gated after clk_enable and clk_disable
called from device_link_add(->pm_runtime_resume) and rpm_idle. The clock
operation happened before display driver probe. At that time, the display
HW will be abnormal.
2) A deadlock issue reported in [2]. Use DL_FLAG_STATELESS to skip
pm_runtime_xx to avoid the deadlock.
Corresponding, DL_FLAG_AUTOREMOVE_CONSUMER can't be added, then
device_link_removed should be added explicitly.
Meanwhile, Currently we don't have a device connect with 2 larbs at the
same time. Disallow this case, print the error log.
[1] https://lore.kernel.org/linux-mediatek/1564213888.22908.4.camel@mhfsdcap03/
[2] https://lore.kernel.org/patchwork/patch/1086569/
Suggested-by: Tomasz Figa <tfiga@xxxxxxxxxxxx>
Signed-off-by: Yong Wu <yong.wu@xxxxxxxxxxxx>
Tested-by: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx> # BPI-R2/MT7623
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
