Em Fri, 26 Nov 2021 12:45:23 -0700 Nathan Chancellor <nathan@xxxxxxxxxx> escreveu: > On Wed, Nov 24, 2021 at 08:13:10PM +0100, Mauro Carvalho Chehab wrote: > > If an error occurs while setting the registers at set_frontend, > > it is silently ignored. Yet, the variable status is updated. > > > > Change the logic to return an error if it fails to write values > > to the registers. > > > > Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx> > > I am not super familiar with the different return codes so I assume it > is appropriate (the sites that I see calling set_frontend() appears to > only check for a negative return code). There are a couple of return codes used on media when I/O transfer fails. Some places use -EREMOTEIO. Others use -EIO or -ENXIO. I guess -EREMOTEIO is a little bit better than -EIO for I2C transfers, as the problem usually happened inside an I2C bus at the DVB adapter. > > Reviewed-by: Nathan Chancellor <nathan@xxxxxxxxxx> > > > --- > > > > To avoid mailbombing on a large number of people, only mailing lists were C/C on the cover. > > See [PATCH 00/20] at: https://lore.kernel.org/all/cover.1637781097.git.mchehab+huawei@xxxxxxxxxx/ > > > > drivers/media/dvb-frontends/si21xx.c | 7 ++++--- > > 1 file changed, 4 insertions(+), 3 deletions(-) > > > > diff --git a/drivers/media/dvb-frontends/si21xx.c b/drivers/media/dvb-frontends/si21xx.c > > index e31eb2c5cc4c..001b23588389 100644 > > --- a/drivers/media/dvb-frontends/si21xx.c > > +++ b/drivers/media/dvb-frontends/si21xx.c > > @@ -711,7 +711,7 @@ static int si21xx_set_frontend(struct dvb_frontend *fe) > > int i; > > bool inband_interferer_div2[ALLOWABLE_FS_COUNT]; > > bool inband_interferer_div4[ALLOWABLE_FS_COUNT]; > > - int status; > > + int status = 0; > > > > /* allowable sample rates for ADC in MHz */ > > int afs[ALLOWABLE_FS_COUNT] = { 200, 192, 193, 194, 195, > > @@ -747,8 +747,6 @@ static int si21xx_set_frontend(struct dvb_frontend *fe) > > rf_freq = 10 * c->frequency ; > > data_rate = c->symbol_rate / 100; > > > > - status = PASS; > > - > > band_low = (rf_freq - lnb_lo) - ((lnb_uncertanity * 200) > > + (data_rate * 135)) / 200; > > > > @@ -832,6 +830,9 @@ static int si21xx_set_frontend(struct dvb_frontend *fe) > > state->fs = sample_rate;/*ADC MHz*/ > > si21xx_setacquire(fe, c->symbol_rate, c->fec_inner); > > > > + if (status) > > + return -EREMOTEIO; > > + > > return 0; > > } > > > > -- > > 2.33.1 > > > > Thanks, Mauro
