From: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx> [ Upstream commit e7c617cab7a522fba5b20f9033ee98565b6f3546 ] Calling pm_runtime_get_sync() is bad, since even when it returns an error, pm_runtime_put*() should be called. So, use instead pm_runtime_resume_and_get(). While here, ensure that the error condition will be checked during clock enable an media open() calls. Reviewed-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx> Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/media/platform/marvell-ccic/mcam-core.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/media/platform/marvell-ccic/mcam-core.c b/drivers/media/platform/marvell-ccic/mcam-core.c index 34266fba824f..e56c5e56e824 100644 --- a/drivers/media/platform/marvell-ccic/mcam-core.c +++ b/drivers/media/platform/marvell-ccic/mcam-core.c @@ -918,6 +918,7 @@ static int mclk_enable(struct clk_hw *hw) struct mcam_camera *cam = container_of(hw, struct mcam_camera, mclk_hw); int mclk_src; int mclk_div; + int ret; /* * Clock the sensor appropriately. Controller clock should @@ -931,7 +932,9 @@ static int mclk_enable(struct clk_hw *hw) mclk_div = 2; } - pm_runtime_get_sync(cam->dev); + ret = pm_runtime_resume_and_get(cam->dev); + if (ret < 0) + return ret; clk_enable(cam->clk[0]); mcam_reg_write(cam, REG_CLKCTRL, (mclk_src << 29) | mclk_div); mcam_ctlr_power_up(cam); @@ -1611,7 +1614,9 @@ static int mcam_v4l_open(struct file *filp) ret = sensor_call(cam, core, s_power, 1); if (ret) goto out; - pm_runtime_get_sync(cam->dev); + ret = pm_runtime_resume_and_get(cam->dev); + if (ret < 0) + goto out; __mcam_cam_reset(cam); mcam_set_config_needed(cam, 1); } -- 2.30.2
