V3: - Adds Acked-by as indicated - Stan - Sets bufreq->size = 0 instead of returning -EINVAL in hfi_plat_bufs_v6.c when a buffer type is unknown - Dikshita - Applies work-mode fix to 4xx and 6xx - Stan Tested on rb5, rb3 and db410c https://git.linaro.org/people/bryan.odonoghue/kernel.git/log/?h=tracking-qcomlt-sm8250-venus-integrated-sm8250 yaml: in robh/dt/next 8d3a1cb32124 - (robh/for-next, robh/dt/next) dt-bindings: media: venus: Add sm8250 dt schema (17 hours ago) dts: Resent based on above robh/dt/next application https://lore.kernel.org/linux-arm-msm/20210401174256.1810044-1-bryan.odonoghue@xxxxxxxxxx/T/#t V2: - Adds Acked-by as indicated - Stan - Fixes typo in patch #1 22000000 -> 220000000 - Stan - Fixes setting of clk_set_rate in core_clks_enable unbreaks regression for 1xx/db410c - Stan - "Add 6xx AXI halt logic" * Polled read removed - Stan * Redundant comments removed - Stan * Delay assocaited with LPI write removed entirely experimentation shows a delay is not required - Stan/Bryan - Unifies intbuf_types_6xx_enc and intbuf_types_6xx_dec into intbuf_types_6xx Looking at the code the separate arrays was a NOP anyway - Stan/Bryan - Ensures venus_helper_set_format_constraints() runs for 6xx only - Differentiates stop address between 6xx and >= 4xx 0xdeadb000 >= 4xx 0x00000000 == 6xx - Stan With the fixes in place for db410c I've verified this code now on sm8250/rb5 sdm845/rb3 and msm8916/db410c yaml: pending - acked waiting application https://www.spinics.net/lists/devicetree/msg406892.html dts: pending - will resend when above is applied https://lore.kernel.org/linux-arm-msm/20210222132817.1807788-1-bryan.odonoghue@xxxxxxxxxx/T/#t Reference tree: ssh://git@xxxxxxxxxxxxxx/people/bryan.odonoghue/kernel.git / tracking-qcomlt-sm8250-venus This tree incorporates two sets of patches from Stan - plus the two yaml/dts sets mentioned above. svarbanov-linux-tv/venus-for-next-v5.13 svarbanov-linux-tv/venus-msm8916-fixes There's a small integration error between the 5.13 and msm8916-fixes which I resolved in favor of the bugfix in 5.13 pending - other than that this tree and these patches apply on tip-of-tree and run as indicated on rb5/rb3 and db410c. https://www.spinics.net/lists/linux-arm-msm/msg81291.html V1: This series enables support for 6xx venus encode/decode as found on the sm8250. The new silicon has different base addresses for existing functional blocks within the venus address space. We add a base address offset mechanism to handle this. The offsetting mechanism has been validated on 6xx and 4xx hardware. The sm8250 supports: - h264 - h265 - vp8 - vp9 The driver changes are contingent on yaml and dts patches already in-flight. yaml: pending https://www.spinics.net/lists/devicetree/msg406892.html dts: pending https://lore.kernel.org/linux-arm-msm/20210222132817.1807788-1-bryan.odonoghue@xxxxxxxxxx/T/#t clk: applied https://kernel.googlesource.com/pub/scm/linux/kernel/git/clk/linux/+/clk-next Applies on top of https://git.linuxtv.org/svarbanov/media_tree.git / venus-for-next-v5.12-part2 Bryan O'Donoghue (11): media: venus: Update v6 buffer descriptors media: venus: core: add sm8250 DT compatible and resource data media: venus: core: Add io base variables for each block media: venus: hfi,pm,firmware: Convert to block relative addressing media: venus: core: Add differentiator IS_V6(core) media: venus: core: Add an io base for TZ wrapper regs media: venus: core: Add an io base for AON regs media: venus: core: Hook to V6 base registers when appropriate media: venus: hfi: Read WRAPPER_TZ_CPU_STATUS_V6 on 6xx media: venus: hfi, vdec: v6 Add IS_V6() to existing IS_V4() if locations media: venus: pm: Hook 6xx pm ops into 4xx pm ops Dikshita Agarwal (12): media: venus: hfi: Define block offsets for V6 hardware media: venus: hfi: Define additional 6xx registers media: venus: hfi: Add a 6xx boot logic media: venus: hfi: Add 6xx interrupt support media: venus: core,pm: Vote for min clk freq during venus boot media: venus: hfi: Add 6xx AXI halt logic media: venus: pm: Toggle 6xx wrapper power in vcodec_control media: venus: firmware: Do not toggle WRAPPER_A9SS_SW_RESET on 6xx media: venus: helpers: Add internal buffer list for v6 media: venus: helpers, hfi, vdec: Set actual plane constraints to FW media: venus: hfi: Increase plat_buf_v6 o/p buffer count. media: venus: helper: Decide work mode Stanimir Varbanov (2): media: venus: core,pm: Add handling for resets media: venus: vdec: Fix decoder cmd STOP issue drivers/media/platform/qcom/venus/core.c | 78 +++++++++ drivers/media/platform/qcom/venus/core.h | 19 ++ drivers/media/platform/qcom/venus/firmware.c | 34 ++-- drivers/media/platform/qcom/venus/helpers.c | 71 +++++++- drivers/media/platform/qcom/venus/helpers.h | 3 +- drivers/media/platform/qcom/venus/hfi_cmds.c | 15 +- .../media/platform/qcom/venus/hfi_helper.h | 9 +- .../platform/qcom/venus/hfi_plat_bufs_v6.c | 6 +- .../platform/qcom/venus/hfi_platform_v6.c | 138 +++++++-------- drivers/media/platform/qcom/venus/hfi_venus.c | 164 +++++++++++++----- .../media/platform/qcom/venus/hfi_venus_io.h | 118 ++++++++----- .../media/platform/qcom/venus/pm_helpers.c | 92 +++++++++- drivers/media/platform/qcom/venus/vdec.c | 17 +- drivers/media/platform/qcom/venus/venc.c | 2 +- 14 files changed, 567 insertions(+), 199 deletions(-) -- 2.30.1
