On Fri, Feb 26, 2021 at 11:22:29PM +0000, Colin King wrote:
> From: Colin Ian King <colin.king@xxxxxxxxxxxxx>
>
> The error check on rval from the call to adp1653_get_fault currently
> returns if rval is non-zero. This appears to be incorrect as the
> following if statement checks for various bit settings in rval so
> clearly rval is expected to be non-zero at that point. Coverity
> flagged the if statement up as deadcode. Fix this so the error
> return path only occurs when rval is negative.
>
> Addresses-Coverity: ("Logically dead code")
> Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses")
> Signed-off-by: Colin Ian King <colin.king@xxxxxxxxxxxxx>
> ---
> drivers/media/i2c/adp1653.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/media/i2c/adp1653.c b/drivers/media/i2c/adp1653.c
> index 522a0b10e415..1a4878385394 100644
> --- a/drivers/media/i2c/adp1653.c
> +++ b/drivers/media/i2c/adp1653.c
> @@ -170,7 +170,7 @@ static int adp1653_set_ctrl(struct v4l2_ctrl *ctrl)
> int rval;
>
> rval = adp1653_get_fault(flash);
> - if (rval)
> + if (rval < 0)
> return rval;
This is good, but all the other callers need to fixed as well:
140 static int adp1653_get_ctrl(struct v4l2_ctrl *ctrl)
141 {
142 struct adp1653_flash *flash =
143 container_of(ctrl->handler, struct adp1653_flash, ctrls);
144 int rval;
145
146 rval = adp1653_get_fault(flash);
147 if (rval)
148 return rval;
149
150 ctrl->cur.val = 0;
151
152 if (flash->fault & ADP1653_REG_FAULT_FLT_SCP)
^^^^^^^^^^^^
flash->fault is the equivalent of "rval" for non-negative returns so
this condition can never be true. We should never be returning these
weird firmware ADP1653_REG_FAULT_FLT_SCP fault codes to the v4l2 layers.
153 ctrl->cur.val |= V4L2_FLASH_FAULT_SHORT_CIRCUIT;
154 if (flash->fault & ADP1653_REG_FAULT_FLT_OT)
155 ctrl->cur.val |= V4L2_FLASH_FAULT_OVER_TEMPERATURE;
156 if (flash->fault & ADP1653_REG_FAULT_FLT_TMR)
157 ctrl->cur.val |= V4L2_FLASH_FAULT_TIMEOUT;
158 if (flash->fault & ADP1653_REG_FAULT_FLT_OV)
159 ctrl->cur.val |= V4L2_FLASH_FAULT_OVER_VOLTAGE;
160
161 flash->fault = 0;
162
163 return 0;
164 }
regards,
dan carpenter
