Hi Jacopo, On 16/02/2021 17:41, Jacopo Mondi wrote: > The MAX9271 chip manual prescribes a delay of 5 milliseconds > after the chip exists from low power state. > > Adjust the required delay in the rdacm21 camera module and add it > to the rdacm20 that currently doesn't implement one. > This sounds to me like it should be a common function in the max9271 module: > /* Verify communication with the MAX9271: ping to wakeup. */ > dev->serializer.client->addr = MAX9271_DEFAULT_ADDR; > i2c_smbus_read_byte(dev->serializer.client); > usleep_range(5000, 8000); Especially as that MAX9271_DEFAULT_ADDR should probably be handled directly in the max9271.c file too, and the RDACM's shouldn't care about it. If we end up moving the max9271 'library' into more of a module/device then this would have to be done in it's 'probe' anyway, so it's likely better handled down there...? But ... it's not essential at this point in the series, so if you want to keep this patch as is, Reviewed-by: Kieran Bingham <kieran.bingham+renesas@xxxxxxxxxxxxxxxx> > Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx> > --- > drivers/media/i2c/rdacm20.c | 1 + > drivers/media/i2c/rdacm21.c | 2 +- > 2 files changed, 2 insertions(+), 1 deletion(-) > > diff --git a/drivers/media/i2c/rdacm20.c b/drivers/media/i2c/rdacm20.c > index ea30cc936531..39e4b4241870 100644 > --- a/drivers/media/i2c/rdacm20.c > +++ b/drivers/media/i2c/rdacm20.c > @@ -460,6 +460,7 @@ static int rdacm20_initialize(struct rdacm20_device *dev) > /* Verify communication with the MAX9271: ping to wakeup. */ > dev->serializer.client->addr = MAX9271_DEFAULT_ADDR; > i2c_smbus_read_byte(dev->serializer.client); > + usleep_range(5000, 8000); > > /* Serial link disabled during config as it needs a valid pixel clock. */ > ret = max9271_set_serial_link(&dev->serializer, false); > diff --git a/drivers/media/i2c/rdacm21.c b/drivers/media/i2c/rdacm21.c > index 179d107f494c..b22a2ca5340b 100644 > --- a/drivers/media/i2c/rdacm21.c > +++ b/drivers/media/i2c/rdacm21.c > @@ -453,7 +453,7 @@ static int rdacm21_initialize(struct rdacm21_device *dev) > /* Verify communication with the MAX9271: ping to wakeup. */ > dev->serializer.client->addr = MAX9271_DEFAULT_ADDR; > i2c_smbus_read_byte(dev->serializer.client); > - usleep_range(3000, 5000); > + usleep_range(5000, 8000); > > /* Enable reverse channel and disable the serial link. */ > ret = max9271_set_serial_link(&dev->serializer, false); >
