The unit of the horizontal blanking control on raw sensors is pixels, not
lines. Document this correctly.
Fixes: e4cf8c58af75 ("media: Documentation: media: Document how to write camera sensor drivers")
Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx>
---
Documentation/driver-api/media/camera-sensor.rst | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/Documentation/driver-api/media/camera-sensor.rst b/Documentation/driver-api/media/camera-sensor.rst
index 3fc378b3b269..9c863e3a79ba 100644
--- a/Documentation/driver-api/media/camera-sensor.rst
+++ b/Documentation/driver-api/media/camera-sensor.rst
@@ -94,9 +94,10 @@ large variety of devices beyond camera sensors. Devices that have no analogue
crop, use the full source image size, i.e. pixel array size.
Horizontal and vertical blanking are specified by ``V4L2_CID_HBLANK`` and
-``V4L2_CID_VBLANK``, respectively. The unit of these controls are lines. The
-pixel rate is specified by ``V4L2_CID_PIXEL_RATE`` in the same sub-device. The
-unit of that control is Hz.
+``V4L2_CID_VBLANK``, respectively. The unit of the ``V4L2_CID_HBLANK`` control
+is pixels and the unit of the ``V4L2_CID_VBLANK`` is lines. The pixel rate is
+specified by ``V4L2_CID_PIXEL_RATE`` in the same sub-device. The unit of that
+control is Hz.
Register list based drivers need to implement read-only sub-device nodes for the
purpose. Devices that are not register list based need these to configure the
--
2.29.2
