On Fri, Oct 23, 2020 at 07:45:44PM +0200, Paul Kocialkowski wrote: > The A83T supports MIPI CSI-2 with a composite controller, covering both the > protocol logic and the D-PHY implementation. This controller seems to be found > on the A83T only and probably was abandonned since. > > This implementation splits the protocol and D-PHY registers and uses the PHY > framework internally. The D-PHY is not registered as a standalone PHY driver > since it cannot be used with any other controller. > > There are a few notable points about the controller: > - The initialisation sequence involes writing specific magic init values that > do not seem to make any particular sense given the concerned register fields. > - Interrupts appear to be hitting regardless of the interrupt mask registers, > which can cause a serious flood when transmission errors occur. Ah, so it's a separate driver too. > This work is based on the first version of the driver submitted by > Kévin L'hôpital, which was adapted to mainline from the Allwinner BSP. > This version integrates MIPI CSI-2 support as a standalone V4L2 subdev > instead of merging it in the sun6i-csi driver. > > It was tested on a Banana Pi M3 board with an OV8865 sensor in a 4-lane > configuration. Co-developped-by and SoB from Kevin? Looking at the driver, the same comments from the v3s apply there Maxime
Attachment:
signature.asc
Description: PGP signature
