Hi Sakari, Thank you for the patch. On Tue, Oct 13, 2020 at 05:27:50PM +0300, Sakari Ailus wrote: > Remove extra "is" from sentence explaining V4L2_CID_PIXEL_RATE may be used > to tell the pixel rate used by a transmitter driver. Also call > V4L2_CID_PIXEL_RATE a control. > > Signed-off-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > --- > Documentation/driver-api/media/csi2.rst | 7 +++---- > 1 file changed, 3 insertions(+), 4 deletions(-) > > diff --git a/Documentation/driver-api/media/csi2.rst b/Documentation/driver-api/media/csi2.rst > index e1b838014906..e3bbc6baf0f0 100644 > --- a/Documentation/driver-api/media/csi2.rst > +++ b/Documentation/driver-api/media/csi2.rst > @@ -28,10 +28,9 @@ interface elements must be present on the sub-device represents the > CSI-2 transmitter. > > The V4L2_CID_LINK_FREQ control is used to tell the receiver driver the > -frequency (and not the symbol rate) of the link. The > -V4L2_CID_PIXEL_RATE is may be used by the receiver to obtain the pixel > -rate the transmitter uses. The > -:c:type:`v4l2_subdev_video_ops`->s_stream() callback provides an > +frequency (and not the symbol rate) of the link. The V4L2_CID_PIXEL_RATE > +control may be used by the receiver to obtain the pixel rate the transmitter > +uses. The :c:type:`v4l2_subdev_video_ops`->s_stream() callback provides an > ability to start and stop the stream. > > The value of the V4L2_CID_PIXEL_RATE is calculated as follows:: -- Regards, Laurent Pinchart
