Hi Hans, On 2020-09-17 11:58:16 +0200, Hans Verkuil wrote: > On 17/09/2020 10:57, Hans Verkuil wrote: > > Hi Prabhakar, > > > > Can you rebase this patch? It no longer applies. > > Never mind, my mistake. When I was preparing this patch I also had this patch > applied: https://patchwork.linuxtv.org/project/linux-media/patch/1595602732-25582-3-git-send-email-prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx/ > > And that caused the conflict with this YDS patch. > > However, I backed out the two renesas-vin-ycbcr-8b-g patches since there were a > bunch comments for https://patchwork.linuxtv.org/project/linux-media/patch/1595602732-25582-2-git-send-email-prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx/ > > So after dropping those two patches this YDS patch now applies fine and will > be included in the PR. Thanks for dropping the renesas-vin-ycbcr-8b-g patches from the PR, they really should not have been picked up as this patch address the issue in a nicer way. To ease your workload would you like me to collect VIN patches and send PR to you for that driver? > > Sorry for the confusion, > > Hans > > > > > Regards, > > > > Hans > > > > On 13/09/2020 20:16, Lad Prabhakar wrote: > >> Enable YDS bit if bus_width and data_shift is set to 8 in parallel mode > >> for MEDIA_BUS_FMT_UYVY8_2X8 format. > >> > >> Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> > >> Reviewed-by: Biju Das <biju.das.jz@xxxxxxxxxxxxxx> > >> --- > >> Changes for v3: > >> * Dropped BIT macro > >> * Introduced struct v4l2_fwnode_bus_parallel > >> > >> Changes for v2: > >> * Dropped DT binding documentation patch > >> * Select the data pins depending on bus-width and data-shift > >> > >> v1 - > >> https://patchwork.kernel.org/project/linux-renesas-soc/list/?series=323799 > >> --- > >> drivers/media/platform/rcar-vin/rcar-core.c | 9 ++++----- > >> drivers/media/platform/rcar-vin/rcar-dma.c | 17 ++++++++++++++--- > >> drivers/media/platform/rcar-vin/rcar-vin.h | 5 +++-- > >> 3 files changed, 21 insertions(+), 10 deletions(-) > >> > >> diff --git a/drivers/media/platform/rcar-vin/rcar-core.c b/drivers/media/platform/rcar-vin/rcar-core.c > >> index 7440c8965d27..1149ab76cf5c 100644 > >> --- a/drivers/media/platform/rcar-vin/rcar-core.c > >> +++ b/drivers/media/platform/rcar-vin/rcar-core.c > >> @@ -626,12 +626,11 @@ static int rvin_parallel_parse_v4l2(struct device *dev, > >> > >> switch (vin->parallel->mbus_type) { > >> case V4L2_MBUS_PARALLEL: > >> - vin_dbg(vin, "Found PARALLEL media bus\n"); > >> - vin->parallel->mbus_flags = vep->bus.parallel.flags; > >> - break; > >> case V4L2_MBUS_BT656: > >> - vin_dbg(vin, "Found BT656 media bus\n"); > >> - vin->parallel->mbus_flags = 0; > >> + vin_dbg(vin, "Found %s media bus\n", > >> + vin->parallel->mbus_type == V4L2_MBUS_PARALLEL ? > >> + "PARALLEL" : "BT656"); > >> + vin->parallel->bus = vep->bus.parallel; > >> break; > >> default: > >> vin_err(vin, "Unknown media bus type\n"); > >> diff --git a/drivers/media/platform/rcar-vin/rcar-dma.c b/drivers/media/platform/rcar-vin/rcar-dma.c > >> index a5dbb90c5210..d067439b0b0d 100644 > >> --- a/drivers/media/platform/rcar-vin/rcar-dma.c > >> +++ b/drivers/media/platform/rcar-vin/rcar-dma.c > >> @@ -125,6 +125,7 @@ > >> #define VNDMR2_VPS (1 << 30) > >> #define VNDMR2_HPS (1 << 29) > >> #define VNDMR2_CES (1 << 28) > >> +#define VNDMR2_YDS (1 << 22) > >> #define VNDMR2_FTEV (1 << 17) > >> #define VNDMR2_VLV(n) ((n & 0xf) << 12) > >> > >> @@ -698,16 +699,26 @@ static int rvin_setup(struct rvin_dev *vin) > >> > >> if (!vin->is_csi) { > >> /* Hsync Signal Polarity Select */ > >> - if (!(vin->parallel->mbus_flags & V4L2_MBUS_HSYNC_ACTIVE_LOW)) > >> + if (!(vin->parallel->bus.flags & V4L2_MBUS_HSYNC_ACTIVE_LOW)) > >> dmr2 |= VNDMR2_HPS; > >> > >> /* Vsync Signal Polarity Select */ > >> - if (!(vin->parallel->mbus_flags & V4L2_MBUS_VSYNC_ACTIVE_LOW)) > >> + if (!(vin->parallel->bus.flags & V4L2_MBUS_VSYNC_ACTIVE_LOW)) > >> dmr2 |= VNDMR2_VPS; > >> > >> /* Data Enable Polarity Select */ > >> - if (vin->parallel->mbus_flags & V4L2_MBUS_DATA_ENABLE_LOW) > >> + if (vin->parallel->bus.flags & V4L2_MBUS_DATA_ENABLE_LOW) > >> dmr2 |= VNDMR2_CES; > >> + > >> + switch (vin->mbus_code) { > >> + case MEDIA_BUS_FMT_UYVY8_2X8: > >> + if (vin->parallel->bus.bus_width == 8 && > >> + vin->parallel->bus.data_shift == 8) > >> + dmr2 |= VNDMR2_YDS; > >> + break; > >> + default: > >> + break; > >> + } > >> } > >> > >> /* > >> diff --git a/drivers/media/platform/rcar-vin/rcar-vin.h b/drivers/media/platform/rcar-vin/rcar-vin.h > >> index c19d077ce1cb..8396e0e45478 100644 > >> --- a/drivers/media/platform/rcar-vin/rcar-vin.h > >> +++ b/drivers/media/platform/rcar-vin/rcar-vin.h > >> @@ -19,6 +19,7 @@ > >> #include <media/v4l2-ctrls.h> > >> #include <media/v4l2-dev.h> > >> #include <media/v4l2-device.h> > >> +#include <media/v4l2-fwnode.h> > >> #include <media/videobuf2-v4l2.h> > >> > >> /* Number of HW buffers */ > >> @@ -92,7 +93,7 @@ struct rvin_video_format { > >> * @asd: sub-device descriptor for async framework > >> * @subdev: subdevice matched using async framework > >> * @mbus_type: media bus type > >> - * @mbus_flags: media bus configuration flags > >> + * @bus: media bus parallel configuration > >> * @source_pad: source pad of remote subdevice > >> * @sink_pad: sink pad of remote subdevice > >> * > >> @@ -102,7 +103,7 @@ struct rvin_parallel_entity { > >> struct v4l2_subdev *subdev; > >> > >> enum v4l2_mbus_type mbus_type; > >> - unsigned int mbus_flags; > >> + struct v4l2_fwnode_bus_parallel bus; > >> > >> unsigned int source_pad; > >> unsigned int sink_pad; > >> > > > -- Regards, Niklas Söderlund