Re: [PATCH v8 08/10] gpu: host1x: mipi: Keep MIPI clock enabled till calibration is done

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 8/6/20 9:41 AM, Sowjanya Komatineni wrote:

On 8/6/20 9:10 AM, Dmitry Osipenko wrote:
06.08.2020 18:59, Sowjanya Komatineni пишет:
...
Confirmed from HW designer, calibration FSM to finish takes worst case
72uS so by the time it gets to sensor stream it will be done its
sequence and will be waiting for DONE bit.

So disabling MIPI CAL clock on sensor stream fails is safe.
72us is quite a lot of time, what will happen if LP-11 happens before
FSM finished calibration?

Maybe the finish_calibration() needs to split into two parts:

   1. wait for CAL_STATUS_ACTIVE before enabling sensor
   2. wait for CAL_STATUS_DONE after enabling sensor
I don't think we need to split for active and done. Active will be 1 as
long as other pads are in calibration as well.

We cant use active status check for specific pads under calibration.
This is common bit for all pads.
Does hardware have a single FSM block shared by all pads or there is FSM
per group of pads?

MIPI CAL status register has DONE bits for individual pads status and single ACTIVE bit.

ACTIVE bit set to 1 indicates auto calibration is active which is the case even when other pads (other CSI pads from other ports streaming in case of parallel stream) are under calibration. Also DSI is shared as well.

We do calibration for individual pads. So, we should not rely on ACTIVE bit.


MIPI driver checks for condition ACTIVE == 1 && DONE == 1 from the beginning.

But I think this also should be fixed as in case of parallel streams calibration can happen in parallel waiting for ACTIVE to be cleared makes all calibration callers to wait for longer than needed as ACTIVE is common for all pads.


Unfortunately HW don't have separate status indicating when sequence is
done to indicate its waiting for LP11.


To avoid all this, will remove cancel_calibration() totally and use same
finish calibration even in case of stream failure then.

What about to add 72us delay to the end of start_calibration() in order
to ensure that FSM is finished before LP-11?

Why we should add 72uS in start_calibration() when can use same finish_calibration() for both pass/fail cases?

Only timing loose we see is in case of failure we still wait for 250ms and as this is failing case I hope should be ok.

Also as we don't need cancel_calibration(), keeping tegra_mipi_wait() like earlier makes sense I believe as we are letting it finish going thru sequence.

So I think below are fixes,

1. Existing MIPI driver, tegra_mipi_wait() to not use status ACTIVE bit to be 0 and use only DONE bit to be 1 for wait condition  as we are calibrating separately for individual pads and this ACTIVE bit is common for all pads where it will not be 0 in case of other parallel streams which may also be under calibration.

2. No need for separate cancel_calibration. So, probably earlier names tegra_mipi_calibrate() and tegra_mipi_wait() hols good as we are waiting for calibration sequence to finish irrespective of fail/pass.





[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux