I just purchased some Hauppauge HVR-1800 cards. They work fine in these
two PCIe slots:
0000:06:00.0
0000:09:00.0
These are "PCI Express* Gen1" slots (see details below); the others are
PCI Express* Gen2.
When I place a card in one of these Gen2 slots, the card does not show up.
What's more, the slot disappears from dmesg. Here's an example.
First, the 0000:04:00.0 slot has no card and shows up like this:
pci 0000:04:00.0: reg 10 64bit mmio: [0xb2000000-0xb21fffff]
pci 0000:04:00.0: supports D1 D2
pci 0000:04:00.0: PME# supported from D0 D1 D2 D3hot D3cold
pci 0000:04:00.0: PME# disabled
Second, using a different card, the Hauppauge HVR-1850, we have no problems:
cx23885 0000:04:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19
cx23885[0]/0: found at 0000:04:00.0, rev: 4, irq: 19, latency: 0, mmio:
0xb2000000
cx23885 0000:04:00.0: setting latency timer to 64
Third, using the Haupauge HVR-1800, the card does not show up *and*
the four pci lines above about mmio and PME are also gone without a trace.
The problem arises only if an HVR-1800 is in one or more of the slots 4,
5, and 6.
These slots are not affected if the HVR-1800 cards are in slots 2 and 3
only.
I get exactly the same behavior on two different machines (same hardware).
The HVR-1800 cards work fine in slots 2 and 3, but fail consistently in
slots 4, 5, and 6.
The slots themselves are known to be good, since other cards work fine
in them.
Is this a known problem? PCI Express Gen2 is supposed to be backwardly
compatible with Gen1, but it looks like these PCIe 1.0 cards are knocking
out the PCIe 2.0 resources.
Cheers,
David
Intel Server Board S3420GPLX has six card slots:
– Slot1: One 5-V PCI 32-bit / 33 MHz connector.
– Slot2: One PCI Express* Gen1 x4 (x1 throughput)
connector).
– Slot3: One PCI Express* Gen1 x8 (x4 throughput)
connector).
– Slot4: One PCI Express* Gen2 x8 (x4 throughput)
connector).
– Slot5: One PCI Express* Gen2x8 (x8 throughput)
connector).
– Slot6: One PCI Express* Gen2 x16 (x8 throughput)
connector).
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
