VI I2C is on host1x bus and is part of VE power domain.
During suspend/resume VE power domain goes through power off/on.
So, controller reset followed by i2c re-initialization is required
after the domain power up.
This patch fixes it.
Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
drivers/i2c/busses/i2c-tegra.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index 1b459ca..e7aad64 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -293,6 +293,8 @@ struct tegra_i2c_dev {
bool is_curr_atomic_xfer;
};
+static int tegra_i2c_init(struct tegra_i2c_dev *i2c_dev, bool clk_reinit);
+
static void dvc_writel(struct tegra_i2c_dev *i2c_dev, u32 val,
unsigned long reg)
{
@@ -679,8 +681,22 @@ static int __maybe_unused tegra_i2c_runtime_resume(struct device *dev)
goto disable_slow_clk;
}
+ /*
+ * VI I2C device is attached to VE power domain which goes through
+ * power ON/OFF during PM runtime resume/suspend. So, controller
+ * should go through reset and need to re-initialize after power
+ * domain ON.
+ */
+ if (i2c_dev->is_vi) {
+ ret = tegra_i2c_init(i2c_dev, true);
+ if (ret)
+ goto disable_div_clk;
+ }
+
return 0;
+disable_div_clk:
+ clk_disable(i2c_dev->div_clk);
disable_slow_clk:
clk_disable(i2c_dev->slow_clk);
disable_fast_clk:
--
2.7.4
