Hi Dave, On Fri, Mar 6, 2020 at 1:01 PM Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> wrote: > > Hi Prabhakar. > > Thanks for the update. > > On Fri, 6 Mar 2020 at 10:32, Lad Prabhakar <prabhakar.csengg@xxxxxxxxx> wrote: > > > > When supporting Rpi Camera v2 Module on the RZ/G2E, found the driver had > > some issues with rcar mipi-csi driver. The sensor never entered into LP-11 > > state. > > > > The powerup sequence in the datasheet[1] shows the sensor entering into > > LP-11 in streaming mode, so to fix this issue transitions are performed > > from "streaming -> standby" in the probe() after power up. > > > > With this commit the sensor is able to enter LP-11 mode during power up, > > as expected by some CSI-2 controllers. > > > > [1] https://publiclab.org/system/images/photos/000/023/294/original/ > > RASPBERRY_PI_CAMERA_V2_DATASHEET_IMX219PQH5_7.0.0_Datasheet_XXX.PDF > > > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> > > Acked-by: Dave Stevenson <dave.stevenson@xxxxxxxxxxxxxxx> > Thank you for the Ack. Cheers, --Prabhakar > > > --- > > drivers/media/i2c/imx219.c | 17 +++++++++++++++++ > > 1 file changed, 17 insertions(+) > > > > diff --git a/drivers/media/i2c/imx219.c b/drivers/media/i2c/imx219.c > > index f1effb5a5f66..16010ca1781a 100644 > > --- a/drivers/media/i2c/imx219.c > > +++ b/drivers/media/i2c/imx219.c > > @@ -1224,6 +1224,23 @@ static int imx219_probe(struct i2c_client *client) > > /* Set default mode to max resolution */ > > imx219->mode = &supported_modes[0]; > > > > + /* sensor doesn't enter LP-11 state upon power up until and unless > > + * streaming is started, so upon power up switch the modes to: > > + * streaming -> standby > > + */ > > + ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT, > > + IMX219_REG_VALUE_08BIT, IMX219_MODE_STREAMING); > > + if (ret < 0) > > + goto error_power_off; > > + usleep_range(100, 110); > > + > > + /* put sensor back to standby mode */ > > + ret = imx219_write_reg(imx219, IMX219_REG_MODE_SELECT, > > + IMX219_REG_VALUE_08BIT, IMX219_MODE_STANDBY); > > + if (ret < 0) > > + goto error_power_off; > > + usleep_range(100, 110); > > + > > ret = imx219_init_controls(imx219); > > if (ret) > > goto error_power_off; > > -- > > 2.20.1 > >
