[PATCH] dt-bindings: media: renesas,ceu: Convert to yaml

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Convert the Renesas CEU bindings description to json-schema and remove
the existing textual bindings document.

Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
---
 .../devicetree/bindings/media/renesas,ceu.txt | 86 -------------------
 .../bindings/media/renesas,ceu.yaml           | 72 ++++++++++++++++
 MAINTAINERS                                   |  2 +-
 3 files changed, 73 insertions(+), 87 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/media/renesas,ceu.txt
 create mode 100644 Documentation/devicetree/bindings/media/renesas,ceu.yaml

diff --git a/Documentation/devicetree/bindings/media/renesas,ceu.txt b/Documentation/devicetree/bindings/media/renesas,ceu.txt
deleted file mode 100644
index 3e2a2652eb19..000000000000
--- a/Documentation/devicetree/bindings/media/renesas,ceu.txt
+++ /dev/null
@@ -1,86 +0,0 @@
-Renesas Capture Engine Unit (CEU)
-----------------------------------------------
-
-The Capture Engine Unit is the image capture interface found in the Renesas
-SH Mobile, R-Mobile and RZ SoCs.
-
-The interface supports a single parallel input with data bus width of 8 or 16
-bits.
-
-Required properties:
-- compatible: Shall be one of the following values:
-	"renesas,r7s72100-ceu" for CEU units found in RZ/A1H and RZ/A1M SoCs
-	"renesas,r8a7740-ceu" for CEU units found in R-Mobile A1 R8A7740 SoCs
-- reg: Registers address base and size.
-- interrupts: The interrupt specifier.
-
-The CEU supports a single parallel input and should contain a single 'port'
-subnode with a single 'endpoint'. Connection to input devices are modeled
-according to the video interfaces OF bindings specified in:
-[1] Documentation/devicetree/bindings/media/video-interfaces.txt
-
-Optional endpoint properties applicable to parallel input bus described in
-the above mentioned "video-interfaces.txt" file are supported.
-
-- hsync-active: See [1] for description. If property is not present,
-  default is active high.
-- vsync-active: See [1] for description. If property is not present,
-  default is active high.
-- bus-width: See [1] for description. Accepted values are '8' and '16'.
-  If property is not present, default is '8'.
-- field-even-active: See [1] for description. If property is not present,
-  an even field is identified by a logic 0 (active-low signal).
-
-Example:
-
-The example describes the connection between the Capture Engine Unit and an
-OV7670 image sensor connected to i2c1 interface.
-
-ceu: ceu@e8210000 {
-	reg = <0xe8210000 0x209c>;
-	compatible = "renesas,r7s72100-ceu";
-	interrupts = <GIC_SPI 332 IRQ_TYPE_LEVEL_HIGH>;
-
-	pinctrl-names = "default";
-	pinctrl-0 = <&vio_pins>;
-
-	status = "okay";
-
-	port {
-		ceu_in: endpoint {
-			remote-endpoint = <&ov7670_out>;
-
-			hsync-active = <1>;
-			vsync-active = <0>;
-		};
-	};
-};
-
-i2c1: i2c@fcfee400 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&i2c1_pins>;
-
-	status = "okay";
-
-	clock-frequency = <100000>;
-
-	ov7670: camera@21 {
-		compatible = "ovti,ov7670";
-		reg = <0x21>;
-
-		pinctrl-names = "default";
-		pinctrl-0 = <&vio_pins>;
-
-		reset-gpios = <&port3 11 GPIO_ACTIVE_LOW>;
-		powerdown-gpios = <&port3 12 GPIO_ACTIVE_HIGH>;
-
-		port {
-			ov7670_out: endpoint {
-				remote-endpoint = <&ceu_in>;
-
-				hsync-active = <1>;
-				vsync-active = <0>;
-			};
-		};
-	};
-};
diff --git a/Documentation/devicetree/bindings/media/renesas,ceu.yaml b/Documentation/devicetree/bindings/media/renesas,ceu.yaml
new file mode 100644
index 000000000000..3c4a4ff975ae
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/renesas,ceu.yaml
@@ -0,0 +1,72 @@
+# SPDX-License-Identifier: GPL-2.0-only
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/media/renesas,ceu.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Renesas Capture Engine Unit (CEU) Bindings
+
+maintainers:
+  - Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
+  - linux-renesas-soc@xxxxxxxxxxxxxxx
+
+description: |+
+  The Capture Engine Unit is the image capture interface found in the Renesas SH
+  Mobile, R-Mobile and RZ SoCs. The interface supports a single parallel input
+  with data bus width of 8 or 16 bits.
+
+properties:
+  compatible:
+    enum:
+      - renesas,r7a72100-ceu
+      - renesas,r8a7740-ceu
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    maxItems: 1
+
+  port:
+    type: object
+    additionalProperties: false
+
+    properties:
+       endpoint:
+         type: object
+
+         # Properties described in
+         # Documentation/devicetree/bindings/media/video-interfaces.txt
+         properties:
+           hsync-active: true
+           vsync-active: true
+           field-even-active: false
+           bus-width:
+             enum: [8, 16]
+
+    required:
+      - endpoint
+
+required:
+  - compatible
+  - reg
+  - interrupts
+  - port
+
+examples:
+  - |
+    #include <dt-bindings/interrupt-controller/arm-gic.h>
+
+    ceu: ceu@e8210000 {
+        reg = <0xe8210000 0x209c>;
+        compatible = "renesas,r7s72100-ceu";
+        interrupts = <GIC_SPI 332 IRQ_TYPE_LEVEL_HIGH>;
+
+        port {
+            ceu_in: endpoint {
+                remote-endpoint = <&ov7670_out>;
+                hsync-active = <1>;
+                vsync-active = <0>;
+            };
+        };
+    };
diff --git a/MAINTAINERS b/MAINTAINERS
index 37a977cbac6f..feab894f7584 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -10133,7 +10133,7 @@ L:	linux-media@xxxxxxxxxxxxxxx
 L:	linux-renesas-soc@xxxxxxxxxxxxxxx
 T:	git git://linuxtv.org/media_tree.git
 S:	Supported
-F:	Documentation/devicetree/bindings/media/renesas,ceu.txt
+F:	Documentation/devicetree/bindings/media/renesas,ceu.yaml
 F:	drivers/media/platform/renesas-ceu.c
 F:	include/media/drv-intf/renesas-ceu.h

--
2.23.0




[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux