On Sun, 2019-09-15 at 14:50 +0800, Louis Kuo wrote: > This patch adds the DT binding documentation for the sensor interface > module in Mediatek SoCs. > > Signed-off-by: Louis Kuo <louis.kuo@xxxxxxxxxxxx> > --- > .../bindings/media/mediatek-seninf.txt | 30 +++++++++++++++++++ > 1 file changed, 30 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/mediatek-seninf.txt > > diff --git a/Documentation/devicetree/bindings/media/mediatek-seninf.txt b/Documentation/devicetree/bindings/media/mediatek-seninf.txt > new file mode 100644 > index 000000000000..bf2eb801cb47 > --- /dev/null > +++ b/Documentation/devicetree/bindings/media/mediatek-seninf.txt > @@ -0,0 +1,30 @@ > +* Mediatek seninf MIPI-CSI2 host driver > + > +Seninf MIPI-CSI2 host driver is a HW camera interface controller. It support a widely adopted, > +simple, high-speed protocol primarily intended for point-to-point image and video > +transmission between cameras and host devices. > + > +Required properties: > + - compatible: "mediatek,mt8183-seninf" > + - reg: Must contain an entry for each entry in reg-names. > + - reg-names: Must include the following entries: > + "base_reg": seninf registers base > + "rx_reg": Rx analog registers base Everyone here is a reg. Adding _reg prefix for everyone looks redundant. Same for clock-names. > + - interrupts: interrupt number to the cpu. > + - clocks : clock name from clock manager > + - clock-names: must be CLK_CAM_SENINF and CLK_TOP_MUX_SENINF. > + It is the clocks of seninf > + Joe.C
