On Thu, Jul 04, 2019 at 12:32:27AM +0530, Manivannan Sadhasivam wrote: > Hello, > > This patchset adds support for IMX290 CMOS image sensor from Sony. > Sensor can be programmed through I2C and 4-wire interface but the > current driver only supports I2C interface. Also, the sensor is > capable of outputting frames in following 3 interfaces: > > * CMOS logic parallel SDR output > * Low voltage LVDS serial DDR output > * CSI-2 serial data output > > But the current driver only supports CSI-2 output available from 4 lanes. > In the case of sensor resolution, driver only supports 1920x1080 and > 1280x720 at mid data rate of 445.5 Mpbs. > > The driver has been validated using Framos IMX290 module interfaced to > 96Boards Dragonboard410c. > Ping on the patchset! Thanks, Mani > Thanks, > Mani > > Manivannan Sadhasivam (3): > dt-bindings: media: i2c: Add IMX290 CMOS sensor binding > media: i2c: Add IMX290 CMOS image sensor driver > MAINTAINERS: Add entry for IMX290 CMOS image sensor driver > > .../devicetree/bindings/media/i2c/imx290.txt | 51 ++ > MAINTAINERS | 8 + > drivers/media/i2c/Kconfig | 11 + > drivers/media/i2c/Makefile | 1 + > drivers/media/i2c/imx290.c | 845 ++++++++++++++++++ > 5 files changed, 916 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/i2c/imx290.txt > create mode 100644 drivers/media/i2c/imx290.c > > -- > 2.17.1 >
