Dear, Today decided to dust off my Anysee E30 S2 Plus, and hope to get it to work with the Debian stretch tvheadend server. Once I plug it in however, I see the following: [27054.699829] usb 1-1.6: new high-speed USB device number 7 using ehci-pci [27055.224303] usb 1-1.6: device descriptor read/all, error -71 [27056.187821] usb 1-1.6: new high-speed USB device number 8 using ehci-pci [27057.180465] usb 1-1.6: config 1 interface 0 altsetting 0 bulk endpoint 0x1 has invalid maxpacket 64 [27057.180469] usb 1-1.6: config 1 interface 0 altsetting 0 bulk endpoint 0x81 has invalid maxpacket 64 [27057.180472] usb 1-1.6: config 1 interface 0 altsetting 1 bulk endpoint 0x1 has invalid maxpacket 64 [27057.180474] usb 1-1.6: config 1 interface 0 altsetting 1 bulk endpoint 0x81 has invalid maxpacket 64 [27057.180961] usb 1-1.6: New USB device found, idVendor=1c73, idProduct=861f, bcdDevice= 1.00 [27057.180964] usb 1-1.6: New USB device strings: Mfr=1, Product=2, SerialNumber=0 [27057.180966] usb 1-1.6: Product: anysee-S2(LP) [27057.180967] usb 1-1.6: Manufacturer: AMT.CO.KR [27057.194507] usb 1-1.6: dvb_usb_v2: found a 'Anysee' in warm state [27057.196058] usb 1-1.6: dvb_usb_anysee: firmware version 1.3 hardware id 11 [27057.197957] usb 1-1.6: dvb_usb_v2: will pass the complete MPEG2 transport stream to the software demuxer [27057.197974] dvbdev: DVB: registering new adapter (Anysee) [27057.197978] usb 1-1.6: media controller created [27057.198256] dvbdev: dvb_create_media_entity: media entity 'dvb-demux' registered. [27057.204296] Invalid probe, probably not a CX24116 device [27057.204304] usb 1-1.6: dvb_usb_anysee: Unsupported Anysee version. Please report to <linux-media@xxxxxxxxxxxxxxx>. [27057.204718] usbcore: registered new interface driver dvb_usb_anysee lsusb gives me the following: Bus 001 Device 008: ID 1c73:861f AMT Anysee E30 USB 2.0 DVB-T Receiver uname -a Linux linsrv03 4.19.45 #1 SMP Fri May 24 00:31:25 CEST 2019 x86_64 GNU/Linux This reminded me that in the past, I never actually got the drivers fully to work under Linux. Since it states: Please report to <linux-media@xxxxxxxxxxxxxxx>., here is my report. Is it possible to get it working? Kind regards, Wytse Talsma
