On Tue, Jun 04, 2019 at 06:29:50PM +0200, Clément Péron wrote: > We are using RXINT bits definition when looking at RXSTA register. > > These bits are equal but it's not really proper. > > Introduce the RXSTA bits and use them to have coherency. > > Signed-off-by: Clément Péron <peron.clem@xxxxxxxxx> > --- > drivers/media/rc/sunxi-cir.c | 18 ++++++++++++------ > 1 file changed, 12 insertions(+), 6 deletions(-) > > diff --git a/drivers/media/rc/sunxi-cir.c b/drivers/media/rc/sunxi-cir.c > index 0504ebfc831f..572bd2257d35 100644 > --- a/drivers/media/rc/sunxi-cir.c > +++ b/drivers/media/rc/sunxi-cir.c > @@ -48,11 +48,11 @@ > > /* Rx Interrupt Enable */ > #define SUNXI_IR_RXINT_REG 0x2C > -/* Rx FIFO Overflow */ > +/* Rx FIFO Overflow Interrupt Enable */ > #define REG_RXINT_ROI_EN BIT(0) > -/* Rx Packet End */ > +/* Rx Packet End Interrupt Enable */ > #define REG_RXINT_RPEI_EN BIT(1) > -/* Rx FIFO Data Available */ > +/* Rx FIFO Data Available Interrupt Enable */ > #define REG_RXINT_RAI_EN BIT(4) > > /* Rx FIFO available byte level */ > @@ -60,6 +60,12 @@ > > /* Rx Interrupt Status */ > #define SUNXI_IR_RXSTA_REG 0x30 > +/* Rx FIFO Overflow */ > +#define REG_RXSTA_ROI BIT(0) > +/* Rx Packet End */ > +#define REG_RXSTA_RPE BIT(1) > +/* Rx FIFO Data Available */ > +#define REG_RXSTA_RA BIT(4) I'm fine with it on principle, but if the consistency needs to be maintained then we could just reuse the above defines Maxime -- Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
