Hi Stan, On Mon, May 20, 2019 at 11:47 PM Stanimir Varbanov <stanimir.varbanov@xxxxxxxxxx> wrote: > > Hi Tomasz, > > On 4/24/19 3:39 PM, Tomasz Figa wrote: > > On Wed, Apr 24, 2019 at 9:15 PM Stanimir Varbanov > > <stanimir.varbanov@xxxxxxxxxx> wrote: > >> > >> Hi Hans, > >> > >> On 2/15/19 3:44 PM, Hans Verkuil wrote: > >>> Hi Stanimir, > >>> > >>> I never paid much attention to this patch series since others were busy > >>> discussing it and I had a lot of other things on my plate, but then I heard > >>> that this patch made G_FMT blocking. > >> > >> OK, another option could be to block REQBUF(CAPTURE) until event from hw > >> is received that the stream is parsed and the resolution is correctly > >> set by application. Just to note that I'd think to this like a temporal > >> solution until gstreamer implements v4l events. > >> > >> Is that looks good to you? > > > > Hmm, I thought we concluded that gstreamer sets the width and height > > in OUTPUT queue before querying the CAPTURE queue and so making the > > driver calculate the CAPTURE format based on what's set on OUTPUT > > would work fine. Did I miss something? > > Nobody is miss something. > > First some background about how Venus implements stateful codec API. > > The Venus firmware can generate two events "sufficient" and > "insufficient" buffer requirements (this includes decoder output buffer > size and internal/scratch buffer sizes). Presently I always set minimum > possible decoder resolution no matter what the user said, and by that > way I'm sure that "insufficient" event will always be triggered by the > firmware (the other reason to take this path is because this is the > least-common-divider for all supported Venus hw/fw versions thus common > code in the driver). The reconfiguration (during codec Initialization > sequence) is made from STREAMON(CAPTURE) context. Now, to make that > re-configuration happen I need to wait for "insufficient" event from > firmware in order to know the real coded resolution. > > In the case of gstreamer where v4l2_events support is missing I have to > block (wait for firmware event) REQBUF(CAPTURE) (vb2::queue_setup) or > STREAMON(CAPTURE) (vb2::start_streaming). > > I tried to set the coded resolution to the firmware as-is it set by > gstreamer but then I cannot receive the "sufficient" event for VP8 and > VP9 codecs. So I return back to the solution with minimum resolution above. > > I'm open for suggestions. I think you could still keep setting the minimum size and wait for the "insufficient" event. At the same time, you could speculatively advertise the expected "sufficient" size on the CAPTURE queue before the hardware signals those. Even if you mispredict them, you'll get the event, update the CAPTURE resolution and send the source change event to the application, which would then give you the correct buffers. Would that work for you? Best regards, Tomasz
