Em Sun, 16 Dec 2018 11:37:02 +0100 Markus Dobel <markus.dobel@xxxxxx> escreveu: > On 06.12.2018 19:01, Mauro Carvalho Chehab wrote: > > Em Thu, 06 Dec 2018 18:18:23 +0100 > > Markus Dobel <markus.dobel@xxxxxx> escreveu: > > > >> Hi everyone, > >> > >> I will try if the hack mentioned fixes the issue for me on the weekend > >> (but I assume, as if effectively removes the function). > > > > It should, but it keeps a few changes. Just want to be sure that what > > would be left won't cause issues. If this works, the logic that would > > solve Ryzen DMA fixes will be contained into a single point, making > > easier to maintain it. > > Hi, > > I wanted to have this setup running stable for a few days before > replying, that's why I am answering only now. > > But yes, as expected, with Mauro's hack, the driver has been stable for > me for about a week, with several > scheduled recordings in tvheadend, none of them missed. > > So, adding a reliable detection for affected chipsets, where the `if > (1)` currently is, should work. Markus, Thanks for testing! Brad/Alex, I guess we should then stick with this patch: https://patchwork.linuxtv.org/patch/53351/ The past approach that we used on cx88, bttv and other old drivers were to patch drivers/pci/quirks.c, making them to "taint" DMA memory controllers that were known to bad affect on media devices, and then some logic at the drivers to check for such "taint". However, that would require to touch another subsystem, with usually cause delays. Also, as Alex pointed, this could well be just a matter of incompatibility between the cx23885 and the Ryzen DMA controller, and may not affect any other drivers. So, let's start with a logic like what I proposed, fine tuning it to the Ryzen DMA controllers with we know have troubles with the driver. We need to list the PCI ID of the memory controllers at the device ID table on that patch, though. At the RFC patch, I just added an IOMMU PCI ID from a randon Ryzen CPU: +static struct { + int vendor, dev; +} const broken_dev_id[] = { + /* According with + * https://openbenchmarking.org/system/1703021-RI-AMDZEN08075/Ryzen%207%201800X/lspci, + * 0x1451 is PCI ID for the IOMMU found on Ryzen 7 + */ + { PCI_VENDOR_ID_AMD, 0x1451 }, +}; + Ideally, the ID for the affected Ryzen DMA engines should be there at include/linux/pci_ids.h, instead of hard-coded inside a driver. Also, we should, instead, add there the PCI IDs of the DMA engines that are known to have problems with the cx23885. There one thing that still bothers me: could this problem be due to some BIOS setup [1]? If so, are there any ways for dynamically disabling such features inside the driver? [1] like this: https://www.techarp.com/bios-guide/cpu-pci-write-buffer/ Brad, >From your reports about the DMA issues, do you know what generations of the Ryzen are affected? Alex, Do you know if are there any differences at the IP block for the DMA engine used on different Ryzen CPUs? I mean: I suspect that the engine for Ryzen 2nd generation would likely be different than the one at the 1st generation, but, along the same generation, does the Ryzen 3, 5, 7 and Threadripper use the same DMA engine? Thanks, Mauro
