I picked up an HVR-1800 but the box contained an 1850. Encouraged by other reports of success on this list, I plunged ahead and tried it. However, the driver oopses during loading, and oddly, after that point my terminal loses job control (can't ^C or ^Z anymore... weird.) System is running Fedora 12 with kernel 2.6.31.9-174.fc12.i686.PAE. Stock driver in fedora works, but does not reckognize the 1850. Motherboard is an Intel DG45FC with a Core 2 Duo. So I compiled v4l-dvb from HG against the fedora headers and loaded the new modules, that's when the opps happens. Details below. I tried replacing only the cx23885.ko driver, as well as installing all of the v4l-dvb drivers -- behaviour seemed to be the same. With all drivers installed, system bootup does not complete, udev hangs, but I see the same kernel oops from cx23885. Question: should I be trying this against vanilla kernel? Or should I try investigating the oops to see if I can figure out what's wrong? Any other debug/diagnostics I can provide? Thanks! -Ralph cx23885 driver version 0.0.2 loaded cx23885 0000:02:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 CORE cx23885[0]: subsystem: 0070:8541, board: Hauppauge WinTV-HVR1850 [card=24,autodetected] tveeprom 6-0050: Hauppauge model 85021, rev C5F5, serial# 6396039 tveeprom 6-0050: MAC address is 00-0D-FE-61-98-87 tveeprom 6-0050: tuner model is NXP 18271C2 (idx 155, type 54) tveeprom 6-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88) tveeprom 6-0050: audio processor is CX23888 (idx 40) tveeprom 6-0050: decoder processor is CX23888 (idx 34) tveeprom 6-0050: has radio, has IR receiver, has no IR transmitter cx23885[0]: hauppauge eeprom: model=85021 cx25840 8-0044: cx25 0-21 found @ 0x88 (cx23885[0]) cx25840 8-0044: firmware: requesting v4l-cx23885-avcore-01.fw cx25840 8-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes) cx23885[0]: registered device video0 [mpeg] cx23885_dvb_register() allocating 1 frontend(s) cx23885[0]: cx23885 based dvb card tda18271 6-0060: creating new instance TDA18271HD/C2 detected @ 6-0060 DVB: registering new adapter (cx23885[0]) DVB: registering adapter 0 frontend 0 (Samsung S5H1411 QAM/8VSB Frontend)... cx23885_dev_checkrevision() Hardware revision = 0xd0 cx23885[0]/0: found at 0000:02:00.0, rev: 4, irq: 19, latency: 0, mmio: 0xff400000 cx23885 0000:02:00.0: setting latency timer to 64 IRQ 19/cx23885[0]: IRQF_DISABLED is not guaranteed on shared IRQs input: cx23885 IR (Hauppauge WinTV-HVR as /devices/pci0000:00/0000:00:1c.3/0000:02:00.0/input/input13 Creating IR device irrcv0 BUG: unable to handle kernel paging request at 72727563 IP: [<c05a4fd4>] strcmp+0xf/0x22 *pdpt = 0000000033195001 *pde = 0000000000000000 Oops: 0000 [#1] SMP last sysfs file: /sys/module/i2c_core/initstate Modules linked in: tda18271 s5h1411 cx25840 cx23885(+) ir_common ir_core fuse nfs lockd fscache nfs_acl auth_rpcgss coretemp sunrpc ipv6 cpufreq_ondemand acpi_cpufreq dm_multipath uinput snd_hda_codec_intelhdmi snd_hda_codec_idt snd_hda_intel snd_hda_codec snd_hwdep snd_seq snd_seq_device snd_pcm snd_timer cx2341x videobuf_dma_sg v4l2_common snd videodev v4l1_compat soundcore videobuf_dvb i2c_i801 iTCO_wdt iTCO_vendor_support dvb_core videobuf_core btcx_risc tveeprom e1000e snd_page_alloc serio_raw i915 drm_kms_helper drm i2c_algo_bit i2c_core video output [last unloaded: cx23885] Pid: 1778, comm: insmod Not tainted (2.6.31.9-174.fc12.i686.PAE #1) EIP: 0060:[<c05a4fd4>] EFLAGS: 00010286 CPU: 1 EIP is at strcmp+0xf/0x22 EAX: c08db475 EBX: f312c030 ECX: c050a5e0 EDX: 72727563 ESI: c08db4d3 EDI: 72727563 EBP: f39f3d34 ESP: f39f3d2c DS: 007b ES: 007b FS: 00d8 GS: 00e0 SS: 0068 Process insmod (pid: 1778, ti=f39f2000 task=f31472c0 task.ti=f39f2000) Stack: 72727563 f312c150 f39f3d44 c050a80f f312c150 f39f3d80 f39f3d54 c050a8f1 <0> f39f3d80 f312c150 f39f3d74 c050af25 f39f3d74 f39f3d80 f312c000 f39f3d80 <0> f312c150 fffffff4 f39f3d9c c050a48c f312c000 f312c000 00000000 00000000 Call Trace: [<c050a80f>] ? sysfs_find_dirent+0x1b/0x2c [<c050a8f1>] ? __sysfs_add_one+0x18/0x72 [<c050af25>] ? sysfs_add_one+0x18/0xc2 [<c050a48c>] ? sysfs_add_file_mode+0x4a/0x68 [<c050c097>] ? internal_create_group+0xbd/0x122 [<c050c123>] ? sysfs_create_group+0x11/0x16 [<f883d79b>] ? ir_register_class+0x70/0xa2 [ir_core] [<f883d2a5>] ? ir_input_register+0x1ca/0x217 [ir_core] [<fd0f1916>] ? cx23888_ir_rx_s_parameters+0x283/0x28d [cx23885] [<c077a173>] ? mutex_lock+0x22/0x3c [<fd0f0fdd>] ? cx23885_input_init+0x241/0x27c [cx23885] [<fd0f3f0c>] ? cx23885_initdev+0xa40/0xa8c [cx23885] [<fd10f2fe>] ? cx25840_s_frequency+0x0/0x1c [cx25840] [<c05b1120>] ? local_pci_probe+0x13/0x15 [<c05b1bbd>] ? pci_device_probe+0x48/0x6b [<c063cae2>] ? driver_probe_device+0xbc/0x1b8 [<c063cc26>] ? __driver_attach+0x48/0x64 [<c063c16b>] ? bus_for_each_dev+0x42/0x6c [<c063c8e0>] ? driver_attach+0x19/0x1b [<c063cbde>] ? __driver_attach+0x0/0x64 [<c063c62f>] ? bus_add_driver+0xd0/0x211 [<c059feb0>] ? kset_find_obj+0x23/0x4f [<c063ce7b>] ? driver_register+0x7e/0xe5 [<c05b1d7f>] ? __pci_register_driver+0x3d/0x9a [<f887e000>] ? cx23885_init+0x0/0x29 [cx23885] [<f887e027>] ? cx23885_init+0x27/0x29 [cx23885] [<c040305b>] ? do_one_initcall+0x51/0x13f [<c0462f2a>] ? sys_init_module+0xac/0x1be [<c0408fbb>] ? sysenter_do_call+0x12/0x28 Code: c0 83 c9 ff f2 ae 4f 89 d1 49 78 06 ac aa 84 c0 75 f7 31 c0 aa 89 d8 5b 5e 5f 5d c3 55 89 e5 57 56 0f 1f 44 00 00 89 c6 89 d7 ac <ae> 75 08 84 c0 75 f8 31 c0 eb 04 19 c0 0c 01 5e 5f 5d c3 55 89 EIP: [<c05a4fd4>] strcmp+0xf/0x22 SS:ESP 0068:f39f3d2c CR2: 0000000072727563 ---[ end trace bf0dbdfaa1a0eaec ]--- -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
