Hi all, the remote on my TechnoTrend CT2-4500 is not working with kernel 4.18. The TV-card itself works fine: cx25840 6-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes) cx23885: cx23885_dvb_register() allocating 1 frontend(s) cx23885: cx23885[0]: cx23885 based dvb card i2c i2c-5: Added multiplexed i2c bus 12 si2168 5-0064: Silicon Labs Si2168-B40 successfully identified si2168 5-0064: firmware version: B 4.0.2 si2157 12-0060: Silicon Labs Si2147/2148/2157/2158 successfully attached dvbdev: DVB: registering new adapter (cx23885[0]) cx23885 0000:17:00.0: DVB: registering adapter 0 frontend 0 (Silicon Labs Si2168)... sp2 4-0040: CIMaX SP2 successfully attached cx23885: Technotrend TT-budget CT2-4500 CI MAC address: bc:ea:2b:45:05:68 cx23885: cx23885_dev_checkrevision() Hardware revision = 0xa5 cx23885: cx23885[0]/0: found at 0000:17:00.0, rev: 4, irq: 31, latency: 0, mmio: 0xfe000000 The remote is registered: Registered IR keymap rc-fusionhdtv-mce rc rc0: FusionHDTV as /devices/pci0000:00/0000:00:01.2/0000:15:00.2/0000:16:00.0/0000:17:00.0/i2c-4/4-006b/rc/rc0 input: FusionHDTV as /devices/pci0000:00/0000:00:01.2/0000:15:00.2/0000:16:00.0/0000:17:00.0/i2c-4/4-006b/rc/rc0/input18 rc rc0: lirc_dev: driver ir_kbd_i2c registered at minor = 0, scancode receiver, no transmitter ir-keytable reports: Found /sys/class/rc/rc0/ (/dev/input/event15) with: Name: FusionHDTV Driver: ir_kbd_i2c, table: rc-fusionhdtv-mce lirc device: /dev/lirc0 Supported protocols: unknown Enabled protocols: unknown bus: 24, vendor/product: 0000:0000, version: 0x0000 Repeat delay = 500 ms, repeat period = 125 ms Apparently, no protocols are reported. evtest on /dev/input/event15 reports no events. The error was reported before: http://lirc.10951.n7.nabble.com/Problems-with-cx23885-IR-receiver-td10884.html The remote is working, I verified it with a camera. Regards, Martin
