Re: [PATCH v2 3/5] i2c: adv748x: reuse power up sequence when initializing CSI-2

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Niklas,

Thank you for the patch.

On Thursday, 4 October 2018 23:41:36 EEST Niklas Söderlund wrote:
> From: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> 
> Instead of duplicate the register writes to power on the CSI-2
> transmitter when initialization the hardware reuse the dedicated power
> control functions.
> 
> Signed-off-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> ---
>  drivers/media/i2c/adv748x/adv748x-core.c | 28 ++----------------------
>  1 file changed, 2 insertions(+), 26 deletions(-)

Nice diffstat.

Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>

Please see below for an additional comment.

> diff --git a/drivers/media/i2c/adv748x/adv748x-core.c
> b/drivers/media/i2c/adv748x/adv748x-core.c index
> 721ed6552bc1cde6..41cc0cdd6a5fcef5 100644
> --- a/drivers/media/i2c/adv748x/adv748x-core.c
> +++ b/drivers/media/i2c/adv748x/adv748x-core.c
> @@ -390,19 +390,6 @@ static const struct adv748x_reg_value
> adv748x_init_txa_4lane[] = { {ADV748X_PAGE_TXA, 0x72, 0x11},	/* ADI
> Required Write */
>  	{ADV748X_PAGE_TXA, 0xf0, 0x00},	/* i2c_dphy_pwdn - 1'b0 */
> 
> -	{ADV748X_PAGE_TXA, 0x00, 0x84},	/* Enable 4-lane MIPI */
> -	{ADV748X_PAGE_TXA, 0x00, 0xa4},	/* Set Auto DPHY Timing */
> -
> -	{ADV748X_PAGE_TXA, 0x31, 0x82},	/* ADI Required Write */
> -	{ADV748X_PAGE_TXA, 0x1e, 0x40},	/* ADI Required Write */
> -	{ADV748X_PAGE_TXA, 0xda, 0x01},	/* i2c_mipi_pll_en - 1'b1 */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x02},/* delay 2 */
> -	{ADV748X_PAGE_TXA, 0x00, 0x24 },/* Power-up CSI-TX */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
> -	{ADV748X_PAGE_TXA, 0xc1, 0x2b},	/* ADI Required Write */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
> -	{ADV748X_PAGE_TXA, 0x31, 0x80},	/* ADI Required Write */
> -
>  	{ADV748X_PAGE_EOR, 0xff, 0xff}	/* End of register table */
>  };
> 
> @@ -442,19 +429,6 @@ static const struct adv748x_reg_value
> adv748x_init_txb_1lane[] = { {ADV748X_PAGE_TXB, 0x72, 0x11},	/* ADI
> Required Write */
>  	{ADV748X_PAGE_TXB, 0xf0, 0x00},	/* i2c_dphy_pwdn - 1'b0 */
> 
> -	{ADV748X_PAGE_TXB, 0x00, 0x81},	/* Enable 1-lane MIPI */
> -	{ADV748X_PAGE_TXB, 0x00, 0xa1},	/* Set Auto DPHY Timing */
> -
> -	{ADV748X_PAGE_TXB, 0x31, 0x82},	/* ADI Required Write */
> -	{ADV748X_PAGE_TXB, 0x1e, 0x40},	/* ADI Required Write */
> -	{ADV748X_PAGE_TXB, 0xda, 0x01},	/* i2c_mipi_pll_en - 1'b1 */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x02},/* delay 2 */
> -	{ADV748X_PAGE_TXB, 0x00, 0x21 },/* Power-up CSI-TX */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
> -	{ADV748X_PAGE_TXB, 0xc1, 0x2b},	/* ADI Required Write */
> -	{ADV748X_PAGE_WAIT, 0x00, 0x01},/* delay 1 */
> -	{ADV748X_PAGE_TXB, 0x31, 0x80},	/* ADI Required Write */
> -
>  	{ADV748X_PAGE_EOR, 0xff, 0xff}	/* End of register table */
>  };
> 
> @@ -476,6 +450,7 @@ static int adv748x_reset(struct adv748x_state *state)
>  	if (ret)
>  		return ret;
> 
> +	adv748x_tx_power(&state->txa, 1);
>  	adv748x_tx_power(&state->txa, 0);

This makes me think there's room for further improvement :-)

>  	/* Init and power down TXB */
> @@ -483,6 +458,7 @@ static int adv748x_reset(struct adv748x_state *state)
>  	if (ret)
>  		return ret;
> 
> +	adv748x_tx_power(&state->txb, 1);
>  	adv748x_tx_power(&state->txb, 0);
> 
>  	/* Disable chip powerdown & Enable HDMI Rx block */


-- 
Regards,

Laurent Pinchart







[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux