Hello Loic,
On Thu, Sep 06, 2018 at 10:13:53AM +0200, Loic Poulain wrote:
> On 6 September 2018 at 09:48, jacopo mondi <jacopo@xxxxxxxxxx> wrote:
> > Hello Loic,
> > thanks for looking into this
> >
> > On Tue, Sep 04, 2018 at 07:22:50PM +0200, Loic Poulain wrote:
> >> Hi Jacopo,
> >>
> >> > - ret = ov5640_mod_reg(sensor, OV5640_REG_MIPI_CTRL00, BIT(5),
> >> > - on ? 0 : BIT(5));
> >> > - if (ret)
> >> > - return ret;
> >> > - ret = ov5640_write_reg(sensor, OV5640_REG_PAD_OUTPUT00,
> >> > - on ? 0x00 : 0x70);
> >> > + /*
> >> > + * Enable/disable the MIPI interface
> >> > + *
> >> > + * 0x300e = on ? 0x45 : 0x40
> >> > + * [7:5] = 001 : 2 data lanes mode
> >>
> >> Does 2-Lanes work with this config?
> >> AFAIU, if 2-Lanes is bit 5, value should be 0x25 and 0x20.
> >>
> >
> > Yes, confusing.
> >
> > The sensor manual reports
> > 0x300e[7:5] = 000 one lane mode
> > 0x300e[7:5] = 001 two lanes mode
> >
> > Although this configuration works with 2 lanes, and the application
> > note I have, with the suggested settings for MIPI CSI-2 2 lanes
> > reports 0x40 to be the 2 lanes mode...
> >
> > I used that one, also because the removed entry from the settings blob
> > is:
> > - {0x300e, 0x45, 0, 0}, {0x302e, 0x08, 0, 0}, {0x4300, 0x3f, 0, 0},
> > + {0x302e, 0x08, 0, 0}, {0x4300, 0x3f, 0, 0},
> >
> > So it was using BIT(6) already.
>
> Yes, it was setting BIT(6) from static config and BIT(5) from the
> ov5640_set_stream_mipi function. In your patch you don't set
> BIT(5) anymore.
>
> So it's not clear to me why it is still working, and the datasheet does
> not help a lot on this (BIT(6) is for debug modes).
> FYI I tried with BIT(5) only but it does not work (though I did not
> investigate a lot).
Thanks. Is your setup using 1 or 2 lanes? (I assume 2...)
Another question, unrelated to this specific issue: was the ov5640
working with dragonboard before this patch? I'm asking as I've seen
different behaviors between different platforms, and knowing this
fixes a widespread one like dragonboard is, would help getting this
patches in faster :)
Thanks
j
>
> > Anyway, it works for me with 2 lanes (and I assume Steve), you have tested
> > too, with how many lanes are you working with?
> >
> > Anyway, a comment there might be nice to have... Will add in next
> > version
>
> Definitely.
>
> Regards,
> Loic
Attachment:
signature.asc
Description: PGP signature
