From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
In order to debug the HDMI 5V line we need to add a new v5-gpios
property.
Signed-off-by: Hans Verkuil <hans.verkuil@xxxxxxxxx>
---
.../devicetree/bindings/media/cec-gpio.txt | 17 ++++++++++-------
1 file changed, 10 insertions(+), 7 deletions(-)
diff --git a/Documentation/devicetree/bindings/media/cec-gpio.txt b/Documentation/devicetree/bindings/media/cec-gpio.txt
index 12fcd55ed153..1d53ce89da74 100644
--- a/Documentation/devicetree/bindings/media/cec-gpio.txt
+++ b/Documentation/devicetree/bindings/media/cec-gpio.txt
@@ -4,8 +4,8 @@ The HDMI CEC GPIO module supports CEC implementations where the CEC line
is hooked up to a pull-up GPIO line and - optionally - the HPD line is
hooked up to another GPIO line.
-Please note: the maximum voltage for the CEC line is 3.63V, for the HPD
-line it is 5.3V. So you may need some sort of level conversion circuitry
+Please note: the maximum voltage for the CEC line is 3.63V, for the HPD and
+5V lines it is 5.3V. So you may need some sort of level conversion circuitry
when connecting them to a GPIO line.
Required properties:
@@ -22,15 +22,18 @@ If the CEC line is not associated with an HDMI receiver/transmitter, then
the following property is optional:
- hpd-gpios: gpio that the HPD line is connected to.
+ - v5-gpios: gpio that the 5V line is connected to.
Example for the Raspberry Pi 3 where the CEC line is connected to
-pin 26 aka BCM7 aka CE1 on the GPIO pin header and the HPD line is
-connected to pin 11 aka BCM17 (some level shifter is needed for this!):
+pin 26 aka BCM7 aka CE1 on the GPIO pin header, the HPD line is
+connected to pin 11 aka BCM17 and the 5V line is connected to pin
+15 aka BCM22 (some level shifter is needed for the HPD and 5V lines!):
#include <dt-bindings/gpio/gpio.h>
cec-gpio {
- compatible = "cec-gpio";
- cec-gpios = <&gpio 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
- hpd-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
+ compatible = "cec-gpio";
+ cec-gpios = <&gpio 7 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
+ hpd-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
+ v5-gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
};
--
2.18.0
