Add 'data-enable-active' property to endpoint node properties list. The property allows to specify the polarity of the data-enable signal, which when in active state determinates when data lines have to sampled for valid pixel data. Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx> Reviewed-by: Rob Herring <robh@xxxxxxxxxx> --- Documentation/devicetree/bindings/media/video-interfaces.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/media/video-interfaces.txt b/Documentation/devicetree/bindings/media/video-interfaces.txt index 258b8df..9839d26 100644 --- a/Documentation/devicetree/bindings/media/video-interfaces.txt +++ b/Documentation/devicetree/bindings/media/video-interfaces.txt @@ -109,6 +109,8 @@ Optional endpoint properties Note, that if HSYNC and VSYNC polarities are not specified, embedded synchronization may be required, where supported. - data-active: similar to HSYNC and VSYNC, specifies data line polarity. +- data-enable-active: similar to HSYNC and VSYNC, specifies the data enable + signal polarity. - field-even-active: field signal level during the even field data transmission. - pclk-sample: sample data on rising (1) or falling (0) edge of the pixel clock signal. -- 2.7.4
