Describe the optional endpoint properties for endpoint nodes of port@0
and port@1 of the R-Car VIN driver device tree bindings documentation.
Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
Acked-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
---
v2 -> v3:
- Do not repeat property description, just reference video-interfaces.txt
- Indent with spaces, not tabs as the rest of the document
- Do not remove (yet) the 'bus-width' property from example
---
Documentation/devicetree/bindings/media/rcar_vin.txt | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/Documentation/devicetree/bindings/media/rcar_vin.txt b/Documentation/devicetree/bindings/media/rcar_vin.txt
index 5c6f2a7..4d91a36 100644
--- a/Documentation/devicetree/bindings/media/rcar_vin.txt
+++ b/Documentation/devicetree/bindings/media/rcar_vin.txt
@@ -54,6 +54,14 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
from external SoC pins described in video-interfaces.txt[1].
Describing more then one endpoint in port 0 is invalid. Only VIN
instances that are connected to external pins should have port 0.
+
+ - Optional properties for endpoint nodes of port@0:
+ - hsync-active: see [1] for description. Default is active high.
+ - vsync-active: see [1] for description. Default is active high.
+
+ If both HSYNC and VSYNC polarities are not specified, embedded
+ synchronization is selected.
+
- port 1 - sub-nodes describing one or more endpoints connected to
the VIN from local SoC CSI-2 receivers. The endpoint numbers must
use the following schema.
@@ -63,6 +71,8 @@ from local SoC CSI-2 receivers (port1) depending on SoC.
- Endpoint 2 - sub-node describing the endpoint connected to CSI40
- Endpoint 3 - sub-node describing the endpoint connected to CSI41
+ Endpoint nodes of port@1 do not support any optional endpoint property.
+
Device node example for Gen2 platforms
--------------------------------------
--
2.7.4
