ir_raw_event_set_idle() sends a timeout event which is not needed, and
on startup no reset event is needed either.
Signed-off-by: Sean Young <sean@xxxxxxxx>
---
drivers/media/rc/winbond-cir.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/media/rc/winbond-cir.c b/drivers/media/rc/winbond-cir.c
index 0adf0991f5ab..851acba9b436 100644
--- a/drivers/media/rc/winbond-cir.c
+++ b/drivers/media/rc/winbond-cir.c
@@ -989,8 +989,7 @@ wbcir_init_hw(struct wbcir_data *data)
/* Clear RX state */
data->rxstate = WBCIR_RXSTATE_INACTIVE;
- ir_raw_event_reset(data->dev);
- ir_raw_event_set_idle(data->dev, true);
+ wbcir_idle_rx(data->dev, true);
/* Clear TX state */
if (data->txstate == WBCIR_TXSTATE_ACTIVE) {
@@ -1009,6 +1008,7 @@ wbcir_resume(struct pnp_dev *device)
struct wbcir_data *data = pnp_get_drvdata(device);
wbcir_init_hw(data);
+ ir_raw_event_reset(data->dev);
enable_irq(data->irq);
led_classdev_resume(&data->led);
--
2.17.0
