Hi, Does this card require additional non-GPL binary driver? According to the Wiki it does, whats the kernel to use with it? It does not compile with 2.6.31 02:0c.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card (rev 02) It does not load the frontend: <6>[ 13.055957] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully <6>[ 13.099612] flexcop-pci: will use the HW PID filter. <6>[ 13.117656] flexcop-pci: card revision 2 <6>[ 13.135722] b2c2_flexcop_pci 0000:02:0c.0: enabling device (0004 -> 0007) <7>[ 13.154137] alloc irq_desc for 20 on node -1 <7>[ 13.154143] alloc kstat_irqs on node -1 <6>[ 13.154156] b2c2_flexcop_pci 0000:02:0c.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20 <6>[ 13.190184] DVB: registering new adapter (FlexCop Digital TV device) <6>[ 13.210549] b2c2-flexcop: MAC address = 00:08:c9:e0:96:ff <3>[ 13.229739] CX24123: wrong demod revision: 62 <4>[ 13.524474] mt352_read_register: readreg error (reg=127, ret==-121) <4>[ 13.555822] nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121) <4>[ 13.574430] Unknown/Unsupported NXT chip: 00 00 00 00 00 <4>[ 13.611181] lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121) <4>[ 13.669970] stv0297_readreg: readreg error (reg == 0x80, ret == -121) <7>[ 13.708395] mt312_read: ret == -121 <3>[ 13.708549] b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter <6>[ 13.728109] b2c2_flexcop_pci 0000:02:0c.0: PCI INT A disabled Jonas -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html