Since the GPIO 3 controls both reset and powerdown, we rename it to reset. Fix
the polarity of this, as it is a low active signal and not an high active.
As at it, rename the mipi endpoint in the example to be coherent with the a real
case that will be introduce for imx7 media driver.
Signed-off-by: Rui Miguel Silva <rui.silva@xxxxxxxxxx>
---
Documentation/devicetree/bindings/media/i2c/ov2680.txt | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/Documentation/devicetree/bindings/media/i2c/ov2680.txt b/Documentation/devicetree/bindings/media/i2c/ov2680.txt
index e5d8f130309d..11e925ed9dad 100644
--- a/Documentation/devicetree/bindings/media/i2c/ov2680.txt
+++ b/Documentation/devicetree/bindings/media/i2c/ov2680.txt
@@ -9,8 +9,8 @@ Required Properties:
- AVDD-supply: Analog voltage supply.
Optional Properties:
-- powerdown-gpios: reference to the GPIO connected to the powerdown pin,
- if any. This is an active high signal to the OV2680.
+- reset-gpios: reference to the GPIO connected to the powerdown/reset pin,
+ if any. This is an active low signal to the OV2680.
The device node must contain one 'port' child node for its digital output
video port, and this port must have a single endpoint in accordance with
@@ -30,14 +30,14 @@ Example:
reg = <0x36>;
clocks = <&osc>;
clock-names = "xvclk";
- powerdown-gpios = <&gpio1 3 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&gpio1 3 GPIO_ACTIVE_LOW>;
DOVDD-supply = <&sw2_reg>;
DVDD-supply = <&sw2_reg>;
AVDD-supply = <®_peri_3p15v>;
port {
- ov2680_mipi_ep: endpoint {
- remote-endpoint = <&mipi_sensor_ep>;
+ ov2680_to_mipi: endpoint {
+ remote-endpoint = <&mipi_from_sensor>;
clock-lanes = <0>;
data-lanes = <1>;
};
--
2.17.0
