Hi Jacopo,
On Wed, Apr 25, 2018 at 01:00:13PM +0200, Jacopo Mondi wrote:
> Add device tree bindings documentation for Micron MT9T111/MT9T112 image
> sensors.
>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/mt9t112.txt | 41 +++++++++++++++++++++++++++
> 1 file changed, 41 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mt9t112.txt
>
> diff --git a/Documentation/devicetree/bindings/mt9t112.txt b/Documentation/devicetree/bindings/mt9t112.txt
> new file mode 100644
> index 0000000..cbad475
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mt9t112.txt
> @@ -0,0 +1,41 @@
> +Micron 3.1Mp CMOS Digital Image Sensor
> +--------------------------------------
> +
> +The Micron MT9T111 and MT9T112 are 1/4 inch 3.1Mp System-On-A-Chip (SOC) CMOS
> +digital image sensors which support up to QXGA (2048x1536) image resolution in
> +4/3 format.
> +
> +The sensors can be programmed through a two-wire serial interface and can
> +work both in parallel data output mode as well as in MIPI CSI-2 mode.
> +
> +Required Properties:
> +- compatible: shall be one of the following values
> + "micron,mt9t111" for MT9T111 sensors
> + "micron,mt9t112" for MT9T112 sensors
> +
> +Optional properties:
> +- powerdown-gpios: reference to powerdown input GPIO signal. Pin name "STANDBY".
> + Active level is high.
> +
> +The device node shall contain one 'port' sub-node with one 'endpoint' child
> +node, modeled accordingly to bindings described in:
> +Documentation/devicetree/bindings/media/video-interfaces.txt
> +
> +Example:
> +--------
> +
> + mt9t112@3d {
> + compatible = "micron,mt9t112";
> + reg = <0x3d>;
> +
> + powerdown-gpios = <&gpio4 2 GPIO_ACTIVE_HIGH>;
> +
> + port {
> + mt9t112_out: endpoint {
> + pclk-sample = <1>;
Could you document pclk-sample as an endpoint property? I'd suggest making
it optional with a default configuration.
> + remote-endpoint = <&ceu_in>;
> + };
> + };
> + };
> +
> +
--
Sakari Ailus
e-mail: sakari.ailus@xxxxxx
