Steve,
This code in cx25840-core.c mucks up HVR-1850 IR Tx:
/* Drive GPIO2 direction and values for HVR1700
* where an onboard mux selects the output of demodulator
* vs the 417. Failure to set this results in no DTV.
* It's safe to set this across all Hauppauge boards
* currently, regardless of the board type.
*/
cx25840_write(client, 0x160, 0x1d);
cx25840_write(client, 0x164, 0x00);
This changes the IR_TX pin to act as GPIO_20 and defaults it to low,
keeping the IR Transmitter LED illuminated.
Setting register 0x160 to 0x1f makes the pin the IR Tx function again.
I don't want to hack it in there though, as I don't know the
implications for other CX2388[578] boards. I also perceive the cx23885
module GPIOs could be an easy place to introduce regressions if not
careful.
Steve and Hans,
Any ideas?
I know on the list I had bantered around a configure, enable, set, get
etc v4l2_subdev ops for gpio, but I can't remember the details nor the
requirements.
The cx25840 module really needs a way for the cx23885 bridge driver to
set GPIOs cleanly.
Regards,
Andy
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
