From: Jacob Chen <jacob2.chen@xxxxxxxxxxxxxx>
Add DT bindings documentation for Rockchip MIPI D-PHY RX
Signed-off-by: Jacob Chen <jacob2.chen@xxxxxxxxxxxxxx>
---
.../bindings/media/rockchip-mipi-dphy.txt | 71 ++++++++++++++++++++++
1 file changed, 71 insertions(+)
create mode 100644 Documentation/devicetree/bindings/media/rockchip-mipi-dphy.txt
diff --git a/Documentation/devicetree/bindings/media/rockchip-mipi-dphy.txt b/Documentation/devicetree/bindings/media/rockchip-mipi-dphy.txt
new file mode 100644
index 000000000000..cef9450db051
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/rockchip-mipi-dphy.txt
@@ -0,0 +1,71 @@
+Rockchip SoC MIPI RX D-PHY
+-------------------------------------------------------------
+
+Required properties:
+
+- compatible: value should be one of the following
+ "rockchip,rk3288-mipi-dphy";
+ "rockchip,rk3399-mipi-dphy";
+- rockchip,grf: GRF regs.
+- bus-width : maximum number of data lanes supported (SoC specific);
+- clocks : list of clock specifiers, corresponding to entries in
+ clock-names property;
+- clock-names: required clock name.
+
+The device node should contain two 'port' child node, according to the bindings
+defined in Documentation/devicetree/bindings/media/video-interfaces.txt.
+The first port should be connected to sensor nodes, and the second port should be
+connected to isp node. The following are properties specific to those nodes.
+
+endpoint node
+-------------
+
+- data-lanes : (required) an array specifying active physical MIPI-CSI2
+ data input lanes and their mapping to logical lanes; the
+ array's content is unused, only its length is meaningful;
+
+Device node example
+-------------------
+
+ mipi_dphy_rx0: mipi-dphy-rx0 {
+ compatible = "rockchip,rk3399-mipi-dphy";
+ clocks = <&cru SCLK_MIPIDPHY_REF>,
+ <&cru SCLK_DPHY_RX0_CFG>,
+ <&cru PCLK_VIO_GRF>;
+ clock-names = "dphy-ref", "dphy-cfg", "grf";
+ power-domains = <&power RK3399_PD_VIO>;
+ bus-width = <4>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ mipi_in_wcam: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&wcam_out>;
+ data-lanes = <1 2>;
+ };
+ mipi_in_ucam: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&ucam_out>;
+ data-lanes = <1>;
+ };
+ };
+
+ port@1 {
+ reg = <1>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ dphy_rx0_out: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&isp0_mipi_in>;
+ };
+ };
+ };
+ };
\ No newline at end of file
--
2.15.0
