Hi Oleh, On Mon, Oct 23, 2017 at 5:37 AM, Sean Young <sean@xxxxxxxx> wrote: > Hi Oleh, > > On Sun, Oct 22, 2017 at 05:01:05PM +0300, Oleh Kravchenko wrote: >> Hi, >> >> I'm trying add support remote control for tuners: >> - EvroMedia Full Hybrid Full HD >> - Astrometa T2hybrid >> >> But I'm stuck. Can anybody recognize this protocol? > Is there anything to indicate that there actually a separate IR receiver on the board? Most cx231xx devices have an MCEUSB compliant IR RX/TX built into the chip, and thus they don't use a separate part. Also, IIRC, address 0x30 is the I2C address of the onboard analog frontend for the cx23102, and I suspect you're just reading the values out of the AFE. I suspect you've grabbed a dump from the initial device plug-in, which would coincide with the initial register programming of the AFE. I suspect if you connect the device, let it device settle, *then* start the I2C capture and hit a key on the remote, you'll see traffic on a totally different endpoint which would be the IR traffic being sent back over the IR interface/endpoint. Devin -- Devin J. Heitmueller - Kernel Labs http://www.kernellabs.com
