Luis,
Any comment on these?
On Sun, Oct 01, 2017 at 06:22:37PM +0800, Jacob Chen wrote:
> When I was supporting Rpi Camera Module on the ASUS Tinker board,
> I found this driver have some issues with rockchip's mipi-csi driver.
> It didn't place clock lane in LP-11 state before performing
> D-PHY initialisation.
>
> From our experience, on some OV sensors,
> LP-11 state is not achieved while BIT(5)-0x4800 is cleared.
>
> So let's set BIT(5) and BIT(0) both while not streaming, in order to
> coax the clock lane into LP-11 state.
>
> 0x4800 : MIPI CTRL 00
> BIT(5) : clock lane gate enable
> 0: continuous
> 1: none-continuous
> BIT(0) : manually set clock lane
> 0: Not used
> 1: used
>
> Signed-off-by: Jacob Chen <jacob-chen@xxxxxxxxxx>
> ---
> drivers/media/i2c/ov5647.c | 13 ++++++++++++-
> 1 file changed, 12 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/media/i2c/ov5647.c b/drivers/media/i2c/ov5647.c
> index 95ce90fdb876..247302d01f53 100644
> --- a/drivers/media/i2c/ov5647.c
> +++ b/drivers/media/i2c/ov5647.c
> @@ -253,6 +253,10 @@ static int ov5647_stream_on(struct v4l2_subdev *sd)
> {
> int ret;
>
> + ret = ov5647_write(sd, 0x4800, 0x04);
> + if (ret < 0)
> + return ret;
> +
> ret = ov5647_write(sd, 0x4202, 0x00);
> if (ret < 0)
> return ret;
> @@ -264,6 +268,10 @@ static int ov5647_stream_off(struct v4l2_subdev *sd)
> {
> int ret;
>
> + ret = ov5647_write(sd, 0x4800, 0x25);
> + if (ret < 0)
> + return ret;
> +
> ret = ov5647_write(sd, 0x4202, 0x0f);
> if (ret < 0)
> return ret;
> @@ -320,7 +328,10 @@ static int __sensor_init(struct v4l2_subdev *sd)
> return ret;
> }
>
> - return ov5647_write(sd, 0x4800, 0x04);
> + /*
> + * stream off to make the clock lane into LP-11 state.
> + */
> + return ov5647_stream_off(sd);
> }
>
> static int ov5647_sensor_power(struct v4l2_subdev *sd, int on)
> --
> 2.14.1
>
--
Sakari Ailus
e-mail: sakari.ailus@xxxxxx
