On Mon, Nov 16, 2009 at 3:38 PM, Andrea.Amorosi76@xxxxxxxxx <Andrea.Amorosi76@xxxxxxxxx> wrote: > The usb is the following: > Bus 002 Device 010: ID eb1a:e312 eMPIA Technology, Inc. > (I don't remember what it was previously, but it seems wrong how can I be > sure about that?). > I have put back the driver to the original state, but still it doesn't work. > Did I have to reprogram the eprom? If so, it is possible via usb? > Thank you, > Andrea Well, according to em28xx-cards.c, the EM2882_BOARD_KWORLD_VS_DVBT is eb1a:e323. You can probably just the USB_DEVICE() entry to say e312, and that will allow the driver to load (at which point you can then reprogram the eeprom back to its previous state). I assume that when you used the eeprom rewrite script, that you used a copy of *YOUR* dmesg output from before the problem? You cannot use someone else's dmesg output, as that may not actually match your device. Devin -- Devin J. Heitmueller - Kernel Labs http://www.kernellabs.com -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
