My new Hauppauge HVR-1600 does not load the firmware. The driver was built using the source from over the weekend. I am using mythbuntu. Below is a "modprobe cx18 debug=511" command Any help would greatly be appreciated. [43594.063182] cx18: Start initialization, version 1.2.0 [43594.063306] cx18-0: Initializing card 0 [43594.063312] cx18-0: Autodetected Hauppauge card [43594.063447] cx18-0: info: base addr: 0xdc000000 [43594.063450] cx18-0: info: Enabling pci device [43594.063478] cx18 0000:00:0c.0: PCI INT A -> Link[LNKA] -> GSI 10 (level, low) -> IRQ 10 [43594.063493] cx18-0: info: cx23418 (rev 0) at 00:0c.0, irq: 10, latency: 64, memory: 0xdc000000 [43594.063498] cx18-0: info: attempting ioremap at 0xdc000000 len 0x04000000 [43594.065656] cx18-0: cx23418 revision 01010000 (B) [43594.246946] cx18-0: info: GPIO initial dir: 0000cffe/0000ffff out: 00003001/00000000 [43594.246970] cx18-0: info: activating i2c... [43594.246973] cx18-0: i2c: i2c init [43594.362969] tveeprom 5-0050: Hauppauge model 74041, rev C6B2, serial# 6380357 [43594.362976] tveeprom 5-0050: MAC address is 00-0D-FE-61-5B-45 [43594.362981] tveeprom 5-0050: tuner model is TCL M2523_5N_E (idx 112, type 50) [43594.362987] tveeprom 5-0050: TV standards NTSC(M) (eeprom 0x08) [43594.362991] tveeprom 5-0050: audio processor is CX23418 (idx 38) [43594.362995] tveeprom 5-0050: decoder processor is CX23418 (idx 31) [43594.363000] tveeprom 5-0050: has no radio, has IR receiver, has IR transmitter [43594.363004] cx18-0: Autodetected Hauppauge HVR-1600 [43594.363008] cx18-0: info: NTSC tuner detected [43594.363011] cx18-0: Simultaneous Digital and Analog TV capture supported [43594.542552] IRQ 10/cx18-0: IRQF_DISABLED is not guaranteed on shared IRQs [43594.551681] tuner 6-0061: chip found @ 0xc2 (cx18 i2c driver #0-1) [43594.554867] cs5345 5-004c: chip found @ 0x98 (cx18 i2c driver #0-0) [43594.557430] tuner-simple 6-0061: creating new instance [43594.557436] tuner-simple 6-0061: type set to 50 (TCL 2002N) [43594.558186] cx18-0: info: Allocate encoder MPEG stream: 64 x 32768 buffers (2048kB total) [43594.558268] cx18-0: info: Allocate TS stream: 32 x 32768 buffers (1024kB total) [43594.558310] cx18-0: info: Allocate encoder YUV stream: 16 x 131072 buffers (2048kB total) [43594.558351] cx18-0: info: Allocate encoder VBI stream: 20 x 51984 buffers (1015kB total) [43594.558389] cx18-0: info: Allocate encoder PCM audio stream: 256 x 4096 buffers (1024kB total) [43594.558570] cx18-0: info: Allocate encoder IDX stream: 32 x 32768 buffers (1024kB total) [43594.558732] cx18-0: Registered device video1 for encoder MPEG (64 x 32 kB) [43594.558738] DVB: registering new adapter (cx18) [43594.594104] cx18 0000:00:0c.0: firmware: requesting v4l-cx23418-cpu.fw [43594.607124] cx18-0: Mismatch at offset 0 [43594.607137] cx18-0: Retry loading firmware [43594.608161] cx18 0000:00:0c.0: firmware: requesting v4l-cx23418-cpu.fw [43594.649832] cx18-0: Mismatch at offset 0 [43594.649848] cx18-0: Failed to initialize on minor 3 [43594.682215] cx18-0: Failed to initialize on minor 3 [43594.691048] MXL5005S: Attached at address 0x63 [43594.691063] DVB: registering adapter 0 frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... [43594.708643] cx18-0: DVB Frontend registered [43594.708651] cx18-0: Registered DVB adapter0 for TS (32 x 32 kB) [43594.708711] cx18-0: Registered device video33 for encoder YUV (16 x 128 kB) [43594.708749] cx18-0: Registered device vbi1 for encoder VBI (20 x 51984 bytes) [43594.708785] cx18-0: Registered device video25 for encoder PCM audio (256 x 4 kB) [43594.708790] cx18-0: Initialized card: Hauppauge HVR-1600 [43594.708829] cx18: End initialization [43594.716719] cx18-0: Failed to initialize on minor 4 [43594.723793] cx18-0: Failed to initialize on minor 5 [43594.726277] cx18-0: Failed to initialize on minor 6 [43594.736339] cx18-0: Failed to initialize on minor 6 [43594.757957] cx18-0: Failed to initialize on minor 4 [43594.784206] cx18-0: Failed to initialize on minor 5 Thanks, John -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html