Hi, I'm using Ubuntu 17.04 and I installed the ir-keytable tool. The output of the ir-keytable command is as follows: Found /sys/class/rc/rc0/ (/dev/input/event5) with: Driver ite-cir, table rc-rc6-mce Supported protocols: unknown other lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6 sharp xmp Enabled protocols: lirc rc-6 Name: ITE8708 CIR transceiver bus: 25, vendor/product: 1283:0000, version: 0x0000 Repeat delay = 500 ms, repeat period = 125 ms I'm trying to enable the supported mce_kbd protocol in addition to the lirc and rc-6 protocols with the $ sudo ir-keytable -p lirc -p rc-6 -p mce_kbd command which works as expected. If, however, I reboot my computer, ir-keytable forgets this change and only the lirc and rc-6 protocols are enabled. Is there a configuration file I can edit so that after the boot my IR remote still works? Or is that so that the only way to make it work is to write a start-up script that runs the above command to enable the needed protocol? Thank you in advance! -- Szabolcs
