We're still waiting for an Ack for patch 02/34, right?
Other than that everything is ready AFAICT.
Regards,
Hans
On 07/06/17 20:33, Steve Longerbeam wrote:
> In version 8:
>
> - Switched to v4l2_fwnode APIs.
>
> - Always pass a valid CSI id to ipu_set_ic_src_mux() in imx-ic-prp, even
> if the IC is receiving from the VDIC. The reason is due to a bug in the
> i.MX6 reference manual: from experiment it is determined that the CSI id
> select bit in IPU_CONF register selects which CSI is routed to either
> the VDIC or the IC, and is independent of whether the IC is set to
> receive from a CSI or the VDIC. Sugested by Marek Vasut <marex@xxxxxxx>.
>
> - ov5640: propagate error codes from all i2c register accesses.
> Sugested by Sakari Ailus <sakari.ailus@xxxxxx>.
>
> - ov5640: drop the entity stream count check in ov5640_s_stream().
> Sugested by Sakari Ailus <sakari.ailus@xxxxxx>.
>
> - ov5640: Fix manual exposure control. The manual exposure setting
> (in line periods) cannot exceed the max exposure value in registers
> {0x380E, 0x380F} + {0x350C,0x350D}, however the max eposure value was
> not being calcualted correctly.
>
> - ov5640: the video mode register tables require auto gain/exposure be
> disabled before programming the register set. However auto gain/exp was
> being disabled by direct register write. This caused the auto gain/exp
> control values to be inconsistent with the actual hardware setting. Fixed
> by going through v4l2-ctrl when disabling auto gain/exp.
>
> - ov5640: converted virtual channel macro to a module parameter, default
> to channel 0.
>
> - ov5640: override the v4l2-ctl lock to use the ov5640 subdev driver's
> lock. Sugested by Sakari Ailus <sakari.ailus@xxxxxx>.
>
> - ov5640: switch to unit-less V4L2_CID_EXPOSURE. Using
> V4L2_CID_EXPOSURE_ABSOLUTE will require converting from 100-usec units
> to line periods and vice-versa. Sugested by Sakari Ailus and
> Pavel Machek <pavel@xxxxxx>.
>
> - ov5640: drop dangling regulator_bulk_disable() from probe/remove.
> Sugested by Sakari Ailus <sakari.ailus@xxxxxx>.
>
> - FIM: move input capture channel selection out of the device-tree and
> make this a V4L2 control. In order to support attaching a FIM to prpencvf,
> the FIM cannot have any device-tree configuration, because prpencvf has
> no device node. The FIM now is completely configurable via its V4L2
> controls.
>
> - FIM: drop imx_media_fim_set_power(), and move the input capture channel
> request to imx_media_fim_set_stream(). This allows to drop csi_s_power()
> as well, since the latter only called imx_media_fim_set_power().
>
> - FIM: add a spinlock to protect the frame_interval_monitor() from the
> setting of new control values. The frame_interval_monitor() is called
> from interrupt context so a spinlock must be used.
>
> - Updated to version 8 video-mux patchset from Philipp Zabel
> <p.zabel@xxxxxxxxxxxxxx>.
>
>
> Marek Vasut (1):
> media: imx: Drop warning upon multiple S_STREAM disable calls
>
> Philipp Zabel (8):
> dt-bindings: Add bindings for video-multiplexer device
> ARM: dts: imx6qdl: add multiplexer controls
> ARM: dts: imx6qdl: Add video multiplexers, mipi_csi, and their
> connections
> add mux and video interface bridge entity functions
> platform: add video-multiplexer subdevice driver
> media: imx: csi: increase burst size for YUV formats
> media: imx: csi: add frame skipping support
> media: imx: csi: add sink selection rectangles
>
> Russell King (3):
> media: imx: csi: add support for bayer formats
> media: imx: csi: add frame size/interval enumeration
> media: imx: capture: add frame sizes/interval enumeration
>
> Steve Longerbeam (22):
> [media] dt-bindings: Add bindings for i.MX media driver
> [media] dt/bindings: Add bindings for OV5640
> ARM: dts: imx6qdl: Add compatible, clocks, irqs to MIPI CSI-2 node
> ARM: dts: imx6qdl: add capture-subsystem device
> ARM: dts: imx6qdl-sabrelite: remove erratum ERR006687 workaround
> ARM: dts: imx6-sabrelite: add OV5642 and OV5640 camera sensors
> ARM: dts: imx6-sabresd: add OV5642 and OV5640 camera sensors
> ARM: dts: imx6-sabreauto: create i2cmux for i2c3
> ARM: dts: imx6-sabreauto: add reset-gpios property for max7310_b
> ARM: dts: imx6-sabreauto: add pinctrl for gpt input capture
> ARM: dts: imx6-sabreauto: add the ADV7180 video decoder
> [media] add Omnivision OV5640 sensor driver
> media: Add userspace header file for i.MX
> media: Add i.MX media core driver
> media: imx: Add a TODO file
> media: imx: Add Capture Device Interface
> media: imx: Add CSI subdev driver
> media: imx: Add VDIC subdev driver
> media: imx: Add IC subdev drivers
> media: imx: Add MIPI CSI-2 Receiver subdev driver
> media: imx: set and propagate default field, colorimetry
> ARM: imx_v6_v7_defconfig: Enable staging video4linux drivers
>
> .../devicetree/bindings/media/i2c/ov5640.txt | 45 +
> Documentation/devicetree/bindings/media/imx.txt | 47 +
> .../devicetree/bindings/media/video-mux.txt | 60 +
> Documentation/media/uapi/mediactl/media-types.rst | 21 +
> Documentation/media/v4l-drivers/imx.rst | 614 +++++
> arch/arm/boot/dts/imx6dl-sabrelite.dts | 5 +
> arch/arm/boot/dts/imx6dl-sabresd.dts | 5 +
> arch/arm/boot/dts/imx6dl.dtsi | 189 ++
> arch/arm/boot/dts/imx6q-sabrelite.dts | 5 +
> arch/arm/boot/dts/imx6q-sabresd.dts | 5 +
> arch/arm/boot/dts/imx6q.dtsi | 125 ++
> arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 136 +-
> arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 152 +-
> arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 114 +-
> arch/arm/boot/dts/imx6qdl.dtsi | 20 +-
> arch/arm/configs/imx_v6_v7_defconfig | 11 +
> drivers/media/i2c/Kconfig | 10 +
> drivers/media/i2c/Makefile | 1 +
> drivers/media/i2c/ov5640.c | 2344 ++++++++++++++++++++
> drivers/media/platform/Kconfig | 6 +
> drivers/media/platform/Makefile | 2 +
> drivers/media/platform/video-mux.c | 334 +++
> drivers/staging/media/Kconfig | 2 +
> drivers/staging/media/Makefile | 1 +
> drivers/staging/media/imx/Kconfig | 21 +
> drivers/staging/media/imx/Makefile | 12 +
> drivers/staging/media/imx/TODO | 23 +
> drivers/staging/media/imx/imx-ic-common.c | 113 +
> drivers/staging/media/imx/imx-ic-prp.c | 518 +++++
> drivers/staging/media/imx/imx-ic-prpencvf.c | 1309 +++++++++++
> drivers/staging/media/imx/imx-ic.h | 38 +
> drivers/staging/media/imx/imx-media-capture.c | 775 +++++++
> drivers/staging/media/imx/imx-media-csi.c | 1816 +++++++++++++++
> drivers/staging/media/imx/imx-media-dev.c | 666 ++++++
> drivers/staging/media/imx/imx-media-fim.c | 494 +++++
> drivers/staging/media/imx/imx-media-internal-sd.c | 349 +++
> drivers/staging/media/imx/imx-media-of.c | 270 +++
> drivers/staging/media/imx/imx-media-utils.c | 896 ++++++++
> drivers/staging/media/imx/imx-media-vdic.c | 1009 +++++++++
> drivers/staging/media/imx/imx-media.h | 325 +++
> drivers/staging/media/imx/imx6-mipi-csi2.c | 698 ++++++
> include/linux/imx-media.h | 29 +
> include/media/imx.h | 15 +
> include/uapi/linux/media.h | 6 +
> include/uapi/linux/v4l2-controls.h | 4 +
> 45 files changed, 13613 insertions(+), 27 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/media/i2c/ov5640.txt
> create mode 100644 Documentation/devicetree/bindings/media/imx.txt
> create mode 100644 Documentation/devicetree/bindings/media/video-mux.txt
> create mode 100644 Documentation/media/v4l-drivers/imx.rst
> create mode 100644 drivers/media/i2c/ov5640.c
> create mode 100644 drivers/media/platform/video-mux.c
> create mode 100644 drivers/staging/media/imx/Kconfig
> create mode 100644 drivers/staging/media/imx/Makefile
> create mode 100644 drivers/staging/media/imx/TODO
> create mode 100644 drivers/staging/media/imx/imx-ic-common.c
> create mode 100644 drivers/staging/media/imx/imx-ic-prp.c
> create mode 100644 drivers/staging/media/imx/imx-ic-prpencvf.c
> create mode 100644 drivers/staging/media/imx/imx-ic.h
> create mode 100644 drivers/staging/media/imx/imx-media-capture.c
> create mode 100644 drivers/staging/media/imx/imx-media-csi.c
> create mode 100644 drivers/staging/media/imx/imx-media-dev.c
> create mode 100644 drivers/staging/media/imx/imx-media-fim.c
> create mode 100644 drivers/staging/media/imx/imx-media-internal-sd.c
> create mode 100644 drivers/staging/media/imx/imx-media-of.c
> create mode 100644 drivers/staging/media/imx/imx-media-utils.c
> create mode 100644 drivers/staging/media/imx/imx-media-vdic.c
> create mode 100644 drivers/staging/media/imx/imx-media.h
> create mode 100644 drivers/staging/media/imx/imx6-mipi-csi2.c
> create mode 100644 include/linux/imx-media.h
> create mode 100644 include/media/imx.h
>
