On Tue, May 02, 2017 at 12:17:20PM +0300, Stanimir Varbanov wrote:
> Hi,
>
> On 04/29/2017 11:22 PM, Bjorn Andersson wrote:
> > On Fri 28 Apr 15:02 PDT 2017, Jordan Crouse wrote:
> >
> >> On Fri, Apr 28, 2017 at 12:13:52PM +0300, Stanimir Varbanov wrote:
> >>> +int venus_boot(struct device *parent, struct device *fw_dev)
> >>> +{
> >>> + const struct firmware *mdt;
> >>> + phys_addr_t mem_phys;
> >>> + ssize_t fw_size;
> >>> + size_t mem_size;
> >>> + void *mem_va;
> >>> + int ret;
> >>> +
> >>> + if (!qcom_scm_is_available())
> >>> + return -EPROBE_DEFER;
> >>> +
> >>> + fw_dev->parent = parent;
> >>> + fw_dev->release = device_release_dummy;
> >>> +
> >>> + ret = dev_set_name(fw_dev, "%s:%s", dev_name(parent), "firmware");
> >>> + if (ret)
> >>> + return ret;
> >>> +
> >>> + ret = device_register(fw_dev);
> >>> + if (ret < 0)
> >>> + return ret;
> >>> +
> >>> + ret = of_reserved_mem_device_init_by_idx(fw_dev, parent->of_node, 0);
> >>> + if (ret)
> >>> + goto err_unreg_device;
> >>> +
> >>> + mem_size = VENUS_FW_MEM_SIZE;
> >>> +
> >>> + mem_va = dmam_alloc_coherent(fw_dev, mem_size, &mem_phys, GFP_KERNEL);
> >>> + if (!mem_va) {
> >>> + ret = -ENOMEM;
> >>> + goto err_unreg_device;
> >>> + }
> >>> +
> >>> + ret = request_firmware(&mdt, VENUS_FIRMWARE_NAME, fw_dev);
> >>> + if (ret < 0)
> >>> + goto err_unreg_device;
> >>> +
> >>> + fw_size = qcom_mdt_get_size(mdt);
> >>> + if (fw_size < 0) {
> >>> + ret = fw_size;
> >>> + release_firmware(mdt);
> >>> + goto err_unreg_device;
> >>> + }
> >>> +
> >>> + ret = qcom_mdt_load(fw_dev, mdt, VENUS_FIRMWARE_NAME, VENUS_PAS_ID,
> >>> + mem_va, mem_phys, mem_size);
> >>> +
> >>> + release_firmware(mdt);
> >>> +
> >>> + if (ret)
> >>> + goto err_unreg_device;
> >>> +
> >>> + ret = qcom_scm_pas_auth_and_reset(VENUS_PAS_ID);
> >>> + if (ret)
> >>> + goto err_unreg_device;
> >>> +
> >>> + return 0;
> >>> +
> >>> +err_unreg_device:
> >>> + device_unregister(fw_dev);
> >>> + return ret;
> >>> +}
> >>
> >> Hey, this looks familiar - almost line for line identical to what we'll need to
> >> do for GPU.
> >>
> >> Bjorn - Is this enough to qualify for generic status in the mdt_loader code?
> >> I know its just two consumers, but it would save 50 or 60 lines of code between
> >> the two drivers and be easier to maintain.
> >>
> >
> > I think the code setting up the struct device for memory allocation
> > should be done during probe of the parent, so that I don't think should
> > be shared.
> >
> > The part that allocates memory from a device, loads the mdt into that
> > memory and calls auth_and_reset() sounds like a useful thing to move to
> > the mdt_loader.c
>
> I agree, who is going to do that?
I'll volunteer with the caveat that sometimes I'm not as fast on turning around
code as I would like to be given then organization I'm affiliated with.
That said I do have a stack with my zap shader code pending so it would make
sense to stick it in there.
If the worst happens we can alway merge separately and then consolidate.
Jordan
--
The Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
